Hoshizaki DSM-12CE Manual De Instrucciones página 4

I. INSTALLATION INSTRUCTIONS
1. UNPACKING
WARNING
Children should not be allowed in reach of
the packaging elements (plastic bags and
expanded polystyrene) as they are potential
sources of danger.
CAUTION
Remove shipping carton, tape(s) and packing.
If packing material is left in the ice dispenser,
it will not work properly.
1) After removing the packaging, make sure that
the ice dispenser is in good condition. If in doubt,
please do not use the equipment but apply to
professionally qualified personnel.
2) Remove shipping tapes holding the package of
accessories, and check the contents:
a) Installation Kit
Inlet Hose
Outlet Hose
Rc1/2-G3/4 Nipple
b) Brace
c) Machine Screw
d) Tapping Screw
3) Remove tapes holding the power cord.
Front Panel
Grille
Air Filter
Fig. 1
2. LOCATION
IMPORTANT
1. This ice dispenser is not intended for
outdoor use. Normal operating ambient
temperature should be within 5°C to 40°C.
Normal operating water temperature should
be within 5°C to 35°C. Operation of the ice
dispenser, for extended periods, outside
of these normal temperature ranges may
affect production capacity.
2. The ice dispenser should not be located
next to ovens, grills or other high heat
producing equipment.
3. The location should provide a firm and level
foundation for the equipment at normal
counter top height.
4. Allow 15 cm clearance at rear and top and
5 cm at sides for proper air circulation and
ease of maintenance and/or service should
they be required.
5. This appliance is not suitable for installation
in an area where a water jet could be used
and where dripping is not allowed.
6. Do not place anything on top of the ice
dispenser to obstruct the ventilation louver.
1
1
7. T h i s i c e d i s p e n s e r w i l l n o t w o r k a t
1
subfreezing temperatures. To prevent
1
damage to the water supply line, drain
2
the ice dispenser when air temperature is
2
below zero (see "II. 2. PREPARING THE
ICE DISPENSER FOR LONG STORAGE").
3. INSTALLATION
* Incorrect installation can cause harm to people,
Push Button
animals or things, for which the manufacturer
cannot be held responsible.
Spout
* Secure the ice dispenser to the counter table by
using the brace, machine screws and tapping
screws (accessory). See Fig. 2.
Power Cord
Counter Table
3
ENGLISH
Machine Screw
Tapping Screw
Brace
Fig. 2