Evacuation Of Condensate; Horizontal Configurations; Cadb/Cadt-N-D 05 / 08 / 12 / 18 / 23 / 30 / 45 / 55 / 80 Ch Models; Cadb/Cadt-N-D 05 / 08 / 12 / 18 / 23 / 30 / 45 / 55 / 80 Ch (Bp) Models - S&P CADB-N-D Instrucciones De Uso

7.3.3. EVACUATION OF CONDENSATE

The equipment is supplied with two drains (one for each circuit). For increased security both drains should be connected to the conden-
sate drain. This connection should be made with minimum 22 mm diameter tube with suitable connectors for safe operation. A siphon must
be connected to prevent condensate return.

7.4. HORIZONTAL CONFIGURATIONS

7.4.1. CADB/CADT-N-D 05 / 08 / 12 / 18 / 23 / 30 / 45 /
55 / 80 CH MODELS
Models without an electric heater, but with the possibility of install-
ing a water coil, for post-heating in remote installation configuration,
with a double insulation wall and without by-pass.
The airflows indicated in these configurations can be changed, ac-
cording to the installation.
The installer must only take into account the correct connection of the
evacuation system for water produced by condensation (See section 7.3.3).

7.4.3. CADB/CADT-N-DI 05 / 08 / 12 / 18 / 23 / 30 / 45 / 55 / 80 (A-D-E-G)H MODELS

(Single-phase and three-phase)
Models with double insulating wall, post heating electric heater and without by-pass.
The airflows indicated in these configurations CANNOT be changed, according to the installation.
The installer must take into account the correct connection of the evacuation system for water produced by condensation (See section 7.3.3).
Do not position the post-heating resistances in a different manner to the factory-supplied layout.
CADB/CADT-N-DI 05 / 08 / 12 / 18 / 23 / 30 / 45 / 55 / 80 AH
MODELS
CADB/CADT-N-DI 05 / 08 / 12 / 18 / 23 / 30 / 45 / 55 / 80 EH
MODELS
7.4.2. CADB/CADT-N-D 05 / 08 / 12 / 18 / 23 / 30 / 45 / 55
/ 80 CH (BP) MODELS
Models without an electric heater, but with the possibility of install-
ing a water coil, for post-heating in remote installation configuration,
with a double insulation wall and with a by-pass.
The airflows indicated in these configurations CANNOT be changed,
according to the installation.
The installer must take into account the correct connection of the evacua-
tion system for water produced by condensation (See section 7.3.3).
CADB/CADT-N-DI 05 / 08 / 18 / 23 / 30 / 45 / 55 / 80 DH
MODELS
CADB/CADT-N-DI 05 / 08 / 12 / 18 / 23 / 30 / 45 / 55 / 80 GH
MODELS
27