Installation; Introduction - S&P CADB-N-D Instrucciones De Uso

7. INSTALLATION

7.1. INTRODUCTION

Horizontally configured models, except the 45, 55 and 80 models, are designed to be installed hanging from the ceiling or located inside a false ceiling.
The 05, 08, 12, 18, 23 and 30 models have four metal abutments, one on each lower corner. Using studded rods (Ø 6 mm or Ø 8 mm), it can
be secured to the ceiling and levelled.
The installer must make sure that the ceiling structure and the securing elements can bear the weight of the device, taking into
account that it is a dynamic load.
Vertical configuration models have special support feet.
Once the device has been fitted in the correct position, the installer must connect it with the air duct, the mains connection, both for the
motors, and for the batteries, if applicable, by means of the terminals in the terminal connection box and the connection with the hot water
closed circuit for the water battery, if applicable. The tube for evacuating condensates will be secured according to the instructions in the
corresponding section.
CADB (05/ 08/ 12/ 18/ 23/ 30)
Desagüe (Fig.1)
Desagüe (Fig.1)
a)
a)
b)
x2
x2
x2
Drain (Fig.1)
a) Drainpipe
b) Female screw
c) Joint ring
Install the two drains as indicated in the following drawing:
Tomas de presión (Fig.2)
Drain (Fig.1)
a)
b)
c)
c)
x4 x2
x2 x2
a)
c)
b)
CADB (45, 55, 80)
Tomas de presión (Fig.2)
Pressure tappings (Fig.2)
d)
a)
c)
e) b)
b)
x4 x8
x4
x4
21
Llave
Llave
f)
c)
x8
x1
x1 x1
x1