RIDGID R48607 Manual Del Operador página 13

ASSEMBLY
MOUNTING HOLES
See Figure 8.
WARNING:
Before starting any cutting operation, clamp or bolt
your miter saw to a workbench or an approved mi-
ter saw stand. If a miter saw stand is used, read op-
erator's manual and follow the instructions for the
miter saw stand. Never operate your miter saw on
the floor or in a crouched position. Failure to heed
this warning can result in serious personal injury.
The compound miter saw should be mounted to a firm sup-
porting surface such as a workbench, mounting board, or
miter saw stand. Four bolt holes have been provided in the
saw base for this purpose. Each of the four mounting holes
should be bolted securely using 5/16 in. machine bolts, lock
washers, and hex nuts (not included). Bolts should be of suf-
ficient length to accommodate the saw base, lock washers,
hex nuts, and the thickness of the workbench. Tighten all
four bolts securely.
The hole pattern for mounting to a workbench is shown in
figure 8. Carefully check the workbench after mounting to
make sure that no movement can occur during use. If any
tipping, sliding, or walking is noted, secure the workbench
to the floor before operating.
INSTALLING CARRYING HANDLE
See Figure 9.
 Remove the screws and nuts from the carrying handle
and set aside.
 Slide the carrying handle onto the saw arm, aligning the
holes on the arm with the holes in the handle.
 Insert the screws and nuts into the holes and tighten
securely.
WARNING:
Only use the carry handles on the table and/or
the carry handle on top to move or carry the saw.
Never use the "D" handle and always remove the
battery before moving. Carrying the saw with the
"D" handle may cause inadvertent switch actuation
and may result in serious personal injury.
BLADE WRENCH
See Figure 9.
A blade wrench is packed with this saw. One end of the
wrench is a Phillips screwdriver and the other end is a hex
key. Use the hex key end when installing or removing blade
and the Phillips end when removing or loosening screws. A
storage area for the blade wrench is located in the carrying
handle on the top of the saw.
"D" HANDLE
SCREWS
DUST BAG
See Figure 10.
To install the dust bag and frame assembly, slide the open
end of the frame onto the exhaust port.
For efficient operation, empty the dust bag before it is half
full. This will permit better air flow through the bag.
13 - English
CARRYING
HANDLE
WRENCH
STORAGE
NUTS
EXHAUST
PORT
BLADE
BLADE
WRENCH
Fig. 9
DUST
BAG
Fig. 10