Cable Laying - Waeco PerfectView CRT 100 Instrucciones De Montaje Y De Servicio

Cable laying from the monitor to the camera
Lay the system cable of the camera into the interior of the vehicle.
Install the extension cable from the monitor to the camera (see H 13).
Connect the camera connecting cable with the extension cable (see H 17 ).
Insulate the plug connection with the supplied seal strip (see H 17 and H 18).
Fasten the cable safely in the vehicle in order to avoid it
getting caught (risk of dropping). This can be done by using cable belts, insulating belt
(see H 15 and H 16) or by sticking with glue.
Begin with the sealing of the openings only after all adjustment work at the camera is
concluded and the required lengths of the connecting cables are determined.
Required parts for the cable installation from the camera to the monitor
see H 13 to H 16.
Attention! The plug connection of the system does not offer any protection
against water penetration. Make absolutely sure to provide the connection with
a seal strip. Self-vulcanising seal strip e.g. of 3 M is best suited.
Tip: In order to minimize corrosion in the plug, we recommend you to apply
some grease, e.g. pole fat into one of the plugs.
Further extension cables can be obtained when needed from your dealer or from
WAECO:
Length Article No.
15 m
RV-405
10 m RV-410
15 m RV-415
Electrical connection of the monitor see H 19.
Connect the monitor connecting cable as follows:
– Red cable to terminal 15 (ignition).
– Black cable to terminal 31 (mass).
– Orange cable to the cable (plus +) back-up light.
– White cable to the cable (plus +) instrument lighting.
Laying the cables
56