Machine Setup - Powermatic PM-2X2R Instrucciones De Operación

MACHINE SETUP

routing machine. It is usually unnecessary to change the Machine Setup defaults unless the parameters of the
actual machine change.
Pulse Equivalence – Number of pulses sent by system to stepper motor for each 1mm of movement (unit:
pulse/mm).
Table Size – Preset values; prevents machine over-travel. Verify table size from Specifications.
1. Press or key to select.
2. Press RUN/PAUSE, and input number.
3. Press OK to save.
4. Repeat for Y and Z axis values. Press OK to save all values.
Spindle Delay – Sets the time at which the spindle starts after reading the file (unit: microseconds).
Spindle State
Home Speed – Sets speed separately for each axis when homing; default is X/Y: 3000 mm/min. and Z: 1800
mm/min.
Home Order – Sets desired sequence of axes when homing.
Home Direction – Sets each axis for positive or negative direction, based on Home position.
Acceleration – Can be adjusted to improve line and curve motions; default is 800 mm/s
Start Speed – Sets skip speed and completion speed.
Voltage Setup – Sets input and output terminal status.
C.A.D. Thickness – Thickness of tool touch-off puck. Z-axis movement is established by the software file, but
can be changed here manually.
Max Speed Limit – Sets maximum speed of head movement; defaults are X/Y: 60,000,000; Z+: 1800, Z-: 3000.
Distance Time Limit – Sets period in which machine can sit idle before reverting to continuous mode; default is
30 seconds.
Input Configuration
C.A.D. Position
AUTO PRO SETUP
Work Speed – Sets work speed (default 6000 mm/min.) and fast speed (default 3000 mm/min.).
Safe Height – How high the file can process (mm).
Auto Scale
Fall Scale – Sets fall scale (default 0.200mm) and fall height (default 5.000mm). Fall down scale takes effect
when spindle descends to fall height.
Stop State – Establishes router head stop position after machine is done. Press X+/- to select line; press
RUN/PAUSE to input desired number, then OK.
Machine Setup parameters are set by the manufacturer specifically for your CNC
25
2
.