Front Control Panel (Neomig 2000 Xp - 2400 Xp) - Selco Neomig 1600 Instrucciones De Uso

8 Spot welding time
It allows adjusting the welding time.
Minimum 0.1s, Maximum 10.0s
9 Burn back
Permits adjustment of the wire burn time, preventing
sticking at the end of welding.
Permits adjustment of the length of the wire piece out-
side the torch.
Minimum 0s, Maximum 0.5s, Default 100ms
10 Motor ramp
Allows you to set a gradual transition between the arc
striking wire speed and the final welding wire speed.
Minimum 0s, Maximum 2s, Default 250ms
11 Wire feed
It allows wire feeding without any gas flow and without
the wire being live.
It allows inserting the wire into the torch sheath during
the welding preparatory stages.
12 Post-gas
Permits setting and adjustment of the gas flow at the
end of welding.
Minimum 0s, Maximum 10s, Default 0s
3.3 Front control panel
(Neomig 2000 XP - 2400 XP)
1 Power supply
Indicates that the equipment is connected to the mains
and is on.
2 General alarm
Indicates the possible intervention of protection devices
such as the temperature protection.
26
3 Power on
Indicates the presence of voltage on the equipment
outlet connections.
4 Off/On switch
Turns on the electric power to the welder.
It has two positions, "O" off, and "I" on.
5 Secondary power selector switch
Switch for adjustment with up to 10 positions.
For both switches, the output voltage increases with the
position number.
Never touch the switch while you are welding!
6 7-segment display
Allows the general welding machine parameters to be
displayed during start-up, settings, current and voltage
readings, while welding, and encoding of the alarms.
7 Main adjustment handle
Allows entry to set up, the selection and the setting of
the welding parameters.
Allows wire speed adjustment in manual MIG welding
and synergy correction in synergic MIG welding
Allows continuous adjustment of the wire feed speed.
8 Welding methods
2 Step
In two step, pressing the button causes the gas to flow,
feeds voltage to the wire and makes it advance; when
it is released, the gas, the voltage and the wire feed are
turned off.
4 Step
In four step first pressure on the button causes the gas
to flow with a manual pre-gas time; releasing it activates
the voltage to the wire and its feed.
The following pressure on the button stops the wire and
causes the final process to start which brings the current
back to zero; finally releasing the button turns off the
gas flow.
Wire feed
Allows the manual wire feed without gas flow and with-
out the wire live.
Allows the insertion of the wire into the torch sheath
during the welding preparation phases.
9 Synergy
Allows selection of the manual MIG
process by setting the type of material to be welded.
Manual MIG process
Synergic MIG process, welding of carbon steel
Synergic MIG process, welding of stainless steel
Synergic MIG process, welding of aluminium
.
or synergic MIG