Front Panel (Audio Mixer, Vcf, Hpf, Vca Section) - ARP ODYSSEY Manual De Usuario

ARP ODYSSEY

Front panel (AUDIO MIXER, VCF, HPF, VCA section)

a
b
c
g
h
i
j
n o p q r s
a . VCF FREQ slider (black) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [16Hz...16KHz]
Adjusts how the LPF (Low Pass Filter) is applied.
If the slider is in the lowest position (16 Hz), the high‐frequency range of the
input signal is cut, producing a soft sound. Raising the slider makes the sound
brighter.
b . VCF RESONANCE slider (black) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .[MIN...SELF OSC]
Adjusts the resonance.
This modifies the tonal character by boosting the overtones in the region of the
cutoff point. As you raise the slider, self‐oscillation (a state in which the VCF itself
d
produces a sound) will occur starting at a certain point.
e
c . VCF TYPE switch . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .[ , ,
Selects the type of VCF.
f
: ODYSSEY Rev. 1
: ODYSSEY Rev. 2
: ODYSSEY Rev. 3
d . HPF CUTOFF FREQ slider (black) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [16Hz...16KHz]
Adjusts how the HPF (High Pass Filter) is applied.
As you raise the slider, the low‐frequency region of the input signal is cut,
producing a thinner sound. This is useful when you are simulating the sound of
certain instruments.
e . DRIVE switch . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .[OFF, ON]
By turning this on you can make the VCA distort.
k
f . VCA GAIN slider (black)
l
Adjusts the volume at which the audio signal always passes through the VCA.
m
g . NOISE/RING MOD slider (white)
Adjusts the level of the audio signal that is sent from the noise generator or the
ring modulator.
h . VCO-1 volume slider (blue)
Adjusts the level of the audio signal that is sent from VCO‐1.
i . VCO-2 volume slider (green)
Adjusts the level of the audio signal that is sent from VCO‐2.
j . Filter modulation level slider (black)
Adjusts the level of the signal that controls the VCF FREQ, or adjusts how the
t
signal sent from the S/H MIXER opens and closes the filter.
- 10 -
]