Front Panel (Vcf Section) - ARP 2600 FS Manual Del Usuario

ARP 2600 FS

Front panel (VCF section)

INITIAL OSCILLATOR FREQUENCY INITIAL OSCILLATOR FREQUENCY
g
e
f h
a
b
d
c
t
r
s
q
p
o
n
m
i j k l
VCF (Voltage Controlled Filter)
a . INITIAL FILTER FREQUENCY slider . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [10Hz...10KHz]
Broadly adjusts the cutoff frequency of the LPF (low-pass filter).
Moving the slider toward the left cuts the high-frequency range of the input
signal, producing a softer tone. Moving the slider toward the right produces a
harder and brighter tone.
The frequency range is an approximate value.
b . FINE TUNE slider
Finely adjusts the cutoff frequency
of the LPF.
c . RESONANCE slider
Adjusts the filter resonance level.
This modifies the tonal character by
boosting the overtones in the region
of the cutoff point. As you raise the
slider, self-oscillation (a state in which
the VCF itself produces a sound) will
occur starting at a certain point.
d . TYPE switch . . . . . . . . . . . . . . . . . . . . . . . . . . . . [ , ]
Selects the type of VCF.
TYPE I: ARP 2600 early models
TYPE II: ARP 2600 late models
e . AUDIO input 1 jack
This is the input jack for the VCF
audio signal. RING MODULATOR
is internally connected.
f . AUDIO input 2 jack
This is the input jack for the VCF
audio signal. The square wave of
VCO-1 is internally connected.
g . AUDIO input 3 jack
This is the input jack for the VCF
audio signal. The pulse wave of
VCO-2 is internally connected.
h . AUDIO input 4 jack
This is the input jack for the VCF
audio signal. The sawtooth wave of
VCO-3 is internally connected.
i . AUDIO input 5 jack
This is the input jack for the VCF
audio signal. The noise generator is
internally connected.
- 10 -
j . CV input 1 jack
This is a CV input jack that controls
the VCF cutoff frequency. The KBD
CV is internally connected.
k . CV input 2 jack
This is a CV input jack that controls
the VCF cutoff frequency. The
ADSR is internally connected.
l . CV input 3 jack
This is a CV input jack that controls
the VCF cutoff frequency. The sine
wave of VCO-2 is internally connected.
m . AUDIO input level 1 slider
Adjusts the audio signal level of
VCF AUDIO input 1.
n . AUDIO input level 2 slider
Adjusts the audio signal level of
VCF AUDIO input 2.
o . AUDIO input level 3 slider
Adjusts the audio signal level of
VCF AUDIO input 3.
p . AUDIO input level 4 slider
Adjusts the audio signal level of
VCF AUDIO input 4.
q . AUDIO input level 5 slider
Adjusts the audio signal level of
VCF AUDIO input 5.
r . CV input level 2 slider
Adjusts the signal level of VCF CV
input 2.
s . CV input level 3 slider
Adjusts the signal level of VCF CV
input 3.
t . Output jack
This is the VCF output jack.