Wrench Storage; Safety Switch - Skil 5280 Manual Del Propietário

WARNING
recommended for laser use. Reflective surfaces could direct the beam back toward the
operator.
CAUTION
CAUTION
Using the guide notches without
laser line
For a straight 90° cut, use right side of notch
in the foot. For 45° bevel cuts, use the left side
(Fig. 7a). The cutting guide notch will give an
approximate line of cut. Make sample cuts
in scrap lumber to verify actual line of cut.
This will be helpful because of the number of
different blade types and thicknesses available.
To ensure minimum splintering on the good
side of the material to be cut, face the good
side down.

Wrench storage

Wrench storage is provided on the tool (Fig.
3). Wrench is fully seated when second lock
detent is engaged.
CAUTION
orientation (Fig . 8) . Damage to work piece
could occur if inserted incorrectly.
Power indicator light
When you plug your tool into the power source, the power indicator light will go "ON" indicating
the tool is receiving power (Fig. 1).

Safety switch

The safety switch is designed to prevent accidental starts. To operate safety switch, press
the release button with your thumb on either side of handle to disengage the lock, then pull
the trigger (Fig. 1). When the trigger is released the button will engage the safety switch
automatically, and the trigger will no longer operate. (See SWITCH and GENERAL CUTS.)
18
Never aim the beam at a workpiece with a reflective surface.
shiny reflective sheet steel or similar reflective surfaces are not
Use of controls or adjustments or performance of procedures other than
those specified herein may result in hazardous radiation exposure.
The use of optical instruments with this product will increase eye hazards.
Wrench needs to be
inserted with the correct
Fig. 7a
Fig. 8
Correct
Foot
Incorrect
Bright
90°
45°
Vertical
Bevel
Cuts
Cuts
Blade
Wrench