Intelli Wind Brc1T Menu - Corghi BRC1T-BR300 Manual De Uso

Intelli Wind BRC1T Menu

Machine power-on self test
On power-up, the machine runs a self-test of the connected modules, and the following
screen appears on the display for a few seconds: SELF TEST -12——
This is for the case where there are 2 single-side modules or 1 double-side module con-
nected; the display shows the connection of the first (1) and second (2) side.
Any operating defects in one of these connected modules will be indicated by a dash,
as for the case of non-connected modules.
Subsequently, the display shows the total number of connected heads, and immediately
afterwards a screen appears with 2 items: "MENUS" and "SETTINGS".
This is for the case where there are 2 single-side modules or 1 double-side module con-
nected; the display shows the connection of the first (1) and second (2) side.
Any operating defects in one of these connected modules will be indicated by a dash,
as for the case of non-connected modules.
Subsequently, the display shows the total number of connected heads, and immediately
afterwards a screen appears with 2 items: "MENUS" and "SETTINGS".
Speed set-up
To set the speed, select MENU followed by SPEED.
With the cursor positioned on the speed menu, press "ENTER" 5 fig. 9 so that the cur-
sor shape changes to a curly bracket, then change the value using the "up" and "down"
arrow keys.
To confirm the changes made, press the "ENTER", 5 fig. 9, key again.
The synchronisation difference can also be set by selecting MENU, SPEED and then
SYNCHRONISATION DIFFERENCE.
Change the value of the synchronisation difference in the same way as described previ-
ously for the speed.
The speed can be varied from 300 to 1200 metres / minute in increments of 10 m/min:
from 300 to 1000 metres / minute for 8" machines.
The synchronisation difference can be set to "LOW", "MEDIUM", "HIGH" or "NONE"; this
last value means that there is no synchronisation difference.
Change recipe set-up
To change the value of the parameters of recipe "x", select MENU and then CHANGE
RECIPE X, where "X" is the number of the recipe you wish to change.
To select this number use the "ENTER" key 5 fig.9 and the "up arrow" and "down arrow"
keys 4 fig. 9 to increase or decrease the value, then press the "ENTER" key 5 fig.9 again
to confirm.
Then press the "right" arrow key to access a submenu which shows all the parameters
for that recipe.
To change the name of the recipe, access the submenu of the "CHANGE NAME" parameter.
A "RECIPE NAME" screen appears, in which it is possible to enter an alphanumeric value
in the second line. Press the "ENTER" key to enable editing, use the "up" and "down"
arrow keys to select the desired character or digit, use the "left" and "right" arrow keys to
move the cursor to the next character, and confirm the value by pressing "ENTER".
36 User manual BR