Preparation; Operation - Fujitsu AIRSTAGE UTY-RNK Serie Manual De Funcionamiento

PREPARATION

To set the current day and time
1
Press the TIMER MODE button for
2 seconds or more. The time display
on the remote controller will flash.
3
Press the SET TIME buttons to set the current time.
Press repeatedly to adjust the current time in 1-minute increments. Press and
hold to adjust the current time in 10-minute increments.

OPERATION

Instructions related to heating are applicable to "HEAT PUMP MODELS" and "HEAT RECOVERY MODELS" only.
To start/stop operation
To set the operation mode
G Operation mode setting
* A heat pump model that is not set up as a master unit cannot operate in the AUTO and FAN modes.
* If the priority mode is set to "Priority on Control Indoor Unit", the operating mode of other indoor units except Control
Indoor Unit will be controlled by a Control Indoor Unit.
* If the operating mode of Administrative Indoor Unit is set to "AUTO", "AUTO" is displayed in addition to the display of
current operating mode on other wired remote controllers except Administrative Indoor Unit. In this case, operation of
other indoor units is controlled by the Administrative Indoor Unit.
Example: When operating mode of the Administrative Indoor Unit is set to
"AUTO" while air conditioning setting. (The indication on other
wired remote controllers except Administrative Control Indoor
Unit).
G Room temperature setting
Lower Raise
G Fan speed setting
2
SU MO
SU MO TU WE TH FR SA
ex. Monday 10:00
Press the START/STOP button.
Operation lamp
Air conditioner ON: Lit brightly
Air conditioner OFF: Not lit
Press the FAN button to set the fan speed.
Select Operation mode by pressing the Mode button. It is switched every time as
shown in the below diagram when the button is pressed.
AUTO COOL
Press the SET TEMPERATURE buttons to set the room temperature.
Temperature setting range
AUTO ............................................................ 18 to 30 °C
COOL/DRY .................................................... 18 to 30 °C
HEAT ............................................................. 10, 12, 14, or 16 to 30 °C*
* Room temperatures as low as 10, 12, and 14 °C cannot be set depending on the
model.
Select Operation mode by pressing the Fan speed button. It is switched every time as
shown in the below diagram when the button is pressed.
AUTO HIGH
Press the DAY button and select the current day.
A appears around the selected day.
TU WE TH
4
DRY FAN HEAT
MED LOW
FR SA
Press again to end.
When Administrative
Indoor Unit is set to
"AUTO".
En-2