SICE S 1000 Manual De Instrucciones página 154

Avoid Personal Injury. The operator must read, understand and observe the fol-
lowing instructions:
1. Overinflated tyres can explode, producing hazardous flying debris which may cause
injury.
2. Tyres and rims that do not have the same diameter do not correspond. Do not at-
tempt to mount or inflate tyres with rims that do not correspond. For example, never
mount a 16" tyre on a 16.5" rim, (or vice versa). It is very dangerous. Tyres and rims
that do not correspond could explode, causing accidents.
3. Never exceed the inflation pressure for the tyre (as read on the pressure gauge)
indicated by the manufacturer on the side of the tyre itself.
4. Never place your head or any part of your body over a tyre during the inflation
process or when attempting to seat beads.
This machine is not intended to be a restraining device for exploding tyres, tubes
or rims.
5. Always stand back from the tyre changer when inflating, never lean over.
During this operation, noise levels assessed at 85 dB(A) may occur.
Therefore operators are advised to wear hearing protection devices.
PROCEDURE:
1. Check that both the upper and lower beads and the rim bead seat have been lubricated
adequately with suitable grease for mounting.
2. Clamp the wheel (Fig. 46a).
3. Remove the inner core of the valve, if not already removed (Fig. 46a).
4. Press the
154
CAUTION!
WARNING
button to activate the INFLATRON.
NOTE: If an automatic
work procedure is in use,
activating the device au-
tomatically terminates the
automatic procedure.
46a
46
User manual S 1000