Tabla de contenido
2 WIRES CONNECTION TABLE
n°
DESCRIPTION
1
Power supply
6A
Motor power supply
2
Flashing light
4A, 5A
TX photocell
4B, 5B
RX photocell
6
Key selecton
3
Antenna
Table 1
The table refers to the example of wiring shown in the FORT model manual for sliding motors.
NOTE: If the cables are of a different length than those shown in the table, the section of the cables must be determined based on the actual absorption
of the connected devices.
The requirements are reported in the EN 50575: 2014 standard:
With the publication of the standard EN 50575, in the list of harmonized standards for Regulation CPR 305/2011, Com. 2016 / C 209/03, also electric
cables, already subject to CE marking for the Low Voltage Directive 2014/35 / EU, must be CE marked also under the CPR Regulation.
In the eventualities of connections with devices connected in parallel on the same power supply line, the sizing of the cables shown in Table 1 must be
re-evaluated on the basis of the absorptions and the actual distances.
3 TECHNICAL SPECIFICATIONS
Power supply:
Flashing light output:
Motor output:
Electric lock output:
Photocells power supply:
LV safeties and controls:
Working temperature:
Radio receiver:
Transmitters:
Max TX codes stored in memory:
Board dimension:
Maximum absorbed power:
Fuse 1 :
Fuse 2:
22
COMUNELLO ®Copyright 2019 - All rights reserved
CABLE
LENGTH from 1m to 20m
3G x 1,5 mm
4G x 1,5 mm
EN standard
50575, in the list of
2 x 0.5 mm
harmonized rules
2 x 0.5 mm
for the Regulation
4 x 0.5 mm
CPR 305/2011,
Com.2016/C 209/03
3 x 0.5 mm
230 V~ 50Hz 1600W max.
24 V~ 4W max.
230 V~ 2 x 500 W max.
Dry contact (N.O.) max. 3A to section external power supply
24 V~ 5 W max.
24 V
-20 ÷ 55 °C
433 Mhz
18 Bit o Rolling Code
120 (CODE o CODE PED)
100 x 105 mm.
150W
T 10 A 250V (Delayed fuse)
T 1.6 A 250V (Delayed fuse)
LENGHT from 20m to 50m
2
3G x 2,5 mm
2
4G x 2,5 mm
2
2 x 1.0 mm
2
2 x 1.0 mm
2
4 x 1.0 mm
2
3 x 1.0 mm
Max. 20 m
2
2
2
2
2
2
Tabla de contenido
