Power Supply; Parent Unit; Mains Adapter; Battery - NUK Eco Control + Video Manual De Instrucciones

In both modes you can vary the sensitivity of the baby monitor to adjust the bandwidth of
sounds (chapt. 7.1.1). If you wish to hear very quiet sounds from the baby (= maximum
sensitivity) the baby unit might even transmit sounds from the baby's environment.
3

POWER SUPPLY

3.1

PARENT UNIT

The parent unit may be powered by mains using the mains adapter with the thin plug (fig. 4) or
by a rechargeable battery. When using the battery the parent unit is mobile.
3.1.1

Mains Adapter

Installation of the mains adapter
1. Connect the mains adapter with the thin plug to the jack on the right-hand side of the
parent unit (chapt. 1.3 19 ).
2. Plug the mains adapter into a mains plug.
For your own safety comply with the above described order. Disconnect the unit vice versa: First
disconnect the mains adapter from the wall socket and then from the unit.
Only use the supplied mains adapter.
4
Incorrect adapter types can cause damage to the unit. Before using the mains adapter, check if
it is damaged or if there are uninsulated
damage with the original part only (chapt. 8.3).
Never use a damaged mains adapter.
5
Before connecting the mains adapter: Make sure the voltage shown on the nameplate of
the mains adapter corresponds to the local mains power.
6
3.1.2

Battery

In the parent unit the delivered rechargeable battery may be installed.
Specifications:
• Type BYD SCD530-1
• Material: Lithium Polymer battery, rechargeable, made by BYD
• Output: 3.7 V, 950 mAh (3.5 Wh)
With brightness set to low the battery lasts up to 8 hours*, with brightness set to high up to 5
hours* (*chapt. 10).
Installation of battery (fig. 3):
1. Open the battery compartment of the parent unit by sliding off the battery cover on the
back of the parent unit.
2. Insert contact side of the battery first so that it has complete contact to the terminals
of the parent unit.
3. Push other side of the battery downwards slightly until it clicks into place.
Do not install the battery with force.
7
The battery slides in easily, if you feel resistance you have not followed the order of
Note
installation or positioned the battery incorrectly.
with the thin plug (for specification see chapt. 10):
cables. Replace the mains adapter in case of any
36
Start from the beginning.