Dometic ORIGO 1500 Instrucciones De Uso página 15

Dometic ORIGO
The manufacturer recommends the use of gimbals to mount ORIGO 1500 or
3000 (accessory). Mount the gimbals as follows:
➤ Fasten the gimbal sideplates (1) to the lower body of the stove (3) using
the enclosed nuts and bolts.
NOTE
I
The gimbal arms (2) can be turned to enable the stove (3) to be
lowered forwards or backwards.
➤ Before mounting the gimbal arms (2), make a test by attaching them to
the gimbal sideplates (1) in order to determine which alternative is right
for your boat.
Remember, when the gimbals are in down position, the stovetop must be
raised to full upright position in order to remove the fuel canisters for fill-
ing.
Ensure the installation is done according to fig. 5, page 4.
➤ Place the fibre washers (4) with round holes on the gimbal arms (2).
➤ Lift the stove into position.
➤ Place the fibre washers (5) with oblong holes on the gimbal sidearms (2).
➤ Fasten the screws (6).
➤ Adjust the tension of the screws to the desired friction.
➤ Place a class B-1 fire extinguisher in reaching distance.
7.3 Installing Origo 6000 and 6200 (fig. 6, page 4)
NOTICE! Danger of damaging the device!
A
Before drilling any holes, make sure that no electrical cables or oth-
er parts of the vehicle can be damaged by drilling, sawing and filing.
➤ Determine the best position for the pivot points by placing the range in the
desired position.
➤ Open the stovetop.
➤ Mark the fixing points through the holes in the gimbal sideplates (1).
➤ Remove the range.
➤ Fasten the gimbal arms (2) with fibre washers and screws removed.
EN
Mounting the stove
15