Storage Recommendations; Battery Type; Package Contents - DeWalt DCS727 Manual De Instrucciones

EnGLIsh
Transporting the FLEXVOLT Battery
TM
The D WALT FLEXVOLT TM battery has two modes: Use and Transport.
e
Use Mode: When the FLEXVOLT TM
18V product, it will operate as an 18V battery. When the FLEXVOLT
is in a 54V or a 108V (two 54V batteries) product, it will operate as a 54V
battery.
Transport Mode: When the cap is attached to the FLEXVOLT
battery is in Transport mode. Keep the cap for shipping.
When in Transport mode, strings of cells are
electrically disconnected within the pack
resulting in 3 batteries with a lower Watt
hour (Wh) rating as compared to 1 battery
with a higher Watt hour rating. This increased quantity of 3 batteries with
the lower Watt hour rating can exempt the pack from certain shipping
regulations that are imposed upon the higher Watt hour batteries.
For example, the Transport Wh rating
might indicate 3 x 36 Wh, meaning
3 batteries of 36 Wh each. The Use
Wh rating might indicate 108 Wh
(1 battery implied).

Storage Recommendations

1. The best storage place is one that is cool and dry away from direct
sunlight and excess heat or cold. For optimum battery performance and
life, store battery packs at room temperature when not in use.
2. For long storage, it is recommended to store a fully charged battery
pack in a cool, dry place out of the charger for optimal results.
nOTE: Battery packs should not be stored completely depleted of charge.
The battery pack will need to be recharged before use.
Labels on Charger and Battery Pack
In addition to the pictographs used in this manual, the labels on the charger
and the battery pack may show the following pictographs:
Read instruction manual before use.
See Technical Data for charging time.
Do not probe with conductive objects.
Do not charge damaged battery packs.
Do not expose to water.
Have defective cords replaced immediately.
Charge only between 4 ˚C and 40 ˚C.
Only for indoor use.
Discard the battery pack with due care for the
environment.
Charge D WALT battery packs only with designated
e
D WALT chargers. Charging battery packs other
e
than the designated D
e
D WALT charger may make them burst or lead to
e
other dangerous situations.
46
battery stands alone or is in a D WALT
e
TM battery
battery, the
TM
Example of Use and Transport Label Marking
WALT batteries with a
Do not incinerate the battery pack.
USE (without transport cap). Example: Wh rating
indicates 108 Wh (1 battery with 108 Wh).
TRANSPORT (with built-in transport cap). Example:
Wh rating indicates 3 x 36 Wh (3 batteries of 36 Wh).

Battery Type

The DCS727 operates on a 54 volt battery pack.
These battery packs may be used: DCB546, DCB547, DCB548. Refer to
Technical Data for more information.

Package Contents

The package contains:
1 Assembled mitre saw
1 Blade wrench (assembled on the saw)
1 Saw blade (assembled on the saw)
1 Material clamp
2 Base extensions
2 Screws 2 Washers
1 Li-Ion battery pack (C1, D1, L1, M1, P1, S1, T1, X1, Y1 models)
2 Li-Ion battery packs (C2, D2, L2, M2, P2, S2, T2, X2, Y2 models)
3 Li-Ion battery packs (C3, D3, L3, M3, P3, S3, T3, X3, Y3 models)
1 Instruction manual
nOTE: Battery packs, chargers and kitboxes are not included with N models.
Battery packs and chargers are not included with NT models.
• Check for damage to the tool, parts or accessories which may have
occurred during transport.
• Take the time to thoroughly read and understand this manual prior
to operation.
Markings on Tool
The following pictograms are shown on the tool:
Read instruction manual before use.
Wear ear protection.
Wear eye protection.
Keep hands away from blade.
Visible radiation. Do not stare into light.
Date Code Position (Fig. A)
The date code 8 , which also includes the year of manufacture, is printed
into the housing.
Example:
2019 XX XX
Year of Manufacture