Routine Maintenance - Sabo 72-12 HF Manual Del Operador

30
EN
Hydrostatic transmission
– put the drive release lever into the «ENGAGED»
position (see chap. 4, n° 23), since it is necessary
for the parking brake to be disengaged to ensure
that the speed change lever has enough move-
ment;
– remove the grass-catcher or stone-guard;
– unscrew the knob on the lever (3) and put the lever
into neutral «N» (
in «R» ( for hydrostatic drive models);
– open the access hatch (4) and unscrew the nut (5)
with a 13 mm spanner;
– release the lever (6) so that the deck rests on the
blocks and keep the lever moved sideways so that it
is not in any of the notches. Hold the base of the
seat (7) and tip the cover back.
On closing:
– check that the collector channel (8) is properly fitted
onto its support (9) and resting on the right-hand
guide;
– put the lever (3) into the «R» position and lower the
cover (1) to the height of the levers (3) and (6);
– first put the lever (6) into its housing followed by
lever (3). Lower the cover in line with the fastening
screw.
WARNING!
lowered check that:
– he channel exit (8) is correctly lined up with the
opening in the rear plate (10) and that it is rest-
ing on the support (11).
Then:
– fully tighten the fixing nut (5);
– put the lever (6) into the notch at position «7»;
– take the blocks (2) away, and reassemble the knob on the lever (3) and the access
hatch (4).
6.3

ROUTINE MAINTENANCE

The following table is to help you maintain your machine's safety and performance.
It shows the main maintenance and lubrication operations and their frequency. To the
right of each item, there is a box where you can write the date or after how many oper-
ating hours the work was carried out.
for mechanical drive models), or
When the cover (1) has been
MAINTENANCE
7
10
8
10
9
11
8
6
8