Schulz Compact Serie Manual De Instrucciones página 81

Notes:
- With the compressor operating at maximum pressure, if the belt describes and arc on the driven pulley as if it tried to get out of the groo-
ves, the tension is incorrect.
- At the ideal tension, the belt touches all the traction arc of the driven pulley (right side).
- To measure the force use a tensiometer, which must be purchased at a SCHULZ AUTHORIZED DEALER.
- When the tension of the pulley is not correct, there is overheating and typical noise indicating the belt is slipping.
- Another way to monitor the tension is to monitor the rotation of the air end observing its variation.
4. PROCEDURE FOR REPLACING THE AIR FILTER
Wait for the compressor to cool down before beginning the work. The element of the filter cannot be reused or cleaned.
The air filter is the component responsible for the purity of the air that will be compressed by the air end. The period for changing the air filter
is indicated in Table 13.3. In order to change the air filter of your compressor, follow the procedure below.
- See the procedures 1 before beginning maintenance.
- Remove the fastening nut 1 and the filter 2.
- Remove the restriction indicator of the air filter 4.
- Clean the filter enclosure 3.
- Install the new filter 2 and fastening nut 1.
- Install the restriction indicator of the air filter 4, removed from the old filter.
- Update the information of number of hours for the next change of air filter on the electronic interface of the compressor. The number to be
set is indicated in the parameter table attached to the information folder of your compressor. (Procedure necessary for electronic compres-
sors only).
- Make sure the sealing of the air filter is well seated on the fastening support 3.
Note: Check the restriction of the air filter weekly. If indicator 4 is red, change the filter following the procedure above, even if the number
of hours has not been reached.
FIGURE 13.3 - SRP 3005 TO SRP 3010II
5
Cover
1
3
2
FIGURE 13.4 - SRP 3010 TO SRP 3030
3
2
4
FIGURE 13.6 - SRP 3015 ll
PLASTIC CARCASS FILTER
4
1
3
2
FIGURE 13.7 - SRP 3015 ll
METALIC CARCASS FILTER
81
FIGURE 13.5 - SRP 3040
1
3
2
1
5
2
3