Cabinet Construction - KENMORE ELITE 79041029801 Instrucciones De Instalación

WherelocalcodesDONOTpermitconnectingthe
appliance-grounding c onductorto the neutral
(white) wire, or
if connecting to 4-wire electrical
system (see Figure 6):
1. Disconnect the power supply.
2. Separate the green (or bare copper) and white
appliance cable wires.
3. In the circuit breaker, fuse box or junction box:
connect appliance and residence cable wires as
shown in figure 6.
Cable from
Green Residence Junction
(or Bare Copper) Box
Green
(or Bare Copper)
Wire
White Wire
(Neutral)
Black
White Wire
(Neutral)
U.L.-listed
Cable from Conduit
Appliance Connector
(or CSA listed)
Figure 6 - 4-Wire Electrical System
(Example: Junction Box)
Cabinet Construction
(__ To eliminate the risk of burns or fire
by reaching over heated surface units, do not have
cabinet storage space above the range. If there is
cabinet storage space above range, reduce risk by
installing a range hood that projects horizontally a
minimum of 5" (12.7 cm) beyond the bottom of
the cabinet.
_ Countertop Preparation
• The cooktop sides of the range fit over the
cutout edge of your countertop.
• If you have a square finish (flat) countertop,
no countertop preparation is required. Cooktop
sides lay directly on edge of countertop.
• Formed front-edged countertops must have
molded edge shaved flat 3/4" (1.9 cm) from
each front corner of opening (Figure 7).
• Tile countertops may need trim cut back 3/
4"(1.9 cm)from each front corner and/or
rounded edge flattened (Figure 7).
• If the existing cutout width is greater than
30 1/16" (76,4 cm), reduce the 3A" (1.9 cm)
dimension.
Min.
Cutout
Width
J
(1.9cm)
(81 cm)
Formed or tile countertop
trimmed ¾" (1.9 cm) back at
front corners of countertop
(1.9 cm) opening.
I Figure 7
• Countertop must be level. Place a level on the
countertop, first side to side, then front to back. If the
countertop is not level, the range will not be level. The
oven must be level for satisfactory baking results.
Cooktop sides of range fit over edges of countertop
opening.
_ _ For existing cutout width of 29"
(73.7 cm) (Figure 8):
You must also clear
2 3/16" (5.56 cm) of
material from front
of counterto .J_._
(3.2 cm)
I
Formed or tile countertop trimmed
I_A '' (3.2 cm) back at front corners of
countertop opening.
Figure 8