Operation; General - Hatco HBG Serie Manual De Instalación Y Funcionamiento

General

Use the following procedure to turn on and operate the HBG
and HBGB units.
WARNING
Read all safety messages in the IMPORTANT SAFETy
INFORMATION section before operating this equipment.
NOTICE
Do not turn on unit until it has been cleaned thoroughly.
Ceramic glass surface must be clear of debris to prevent
burn-on.
Use only wipes, pads, and cleaners designed specifically
for cleaning ceramic glass surfaces. Using other wipes,
pads, or cleaners may damage ceramic glass surface.
Do not slide pans across glass surface, use rough-
bottomed pans, or drop anything on glass surface.
Scratching or breakage may occur. Damage to glass
surface or breakage of glass caused by misuse is not
covered under warranty.
1. Using an appropriate cleaning wipe or a damp cloth, clean
the glass surface of the unit. Consistent daily cleaning will
keep cleanup easy as well as protect and preserve the
glass surface of the unit.
2. Plug the unit into a properly grounded electrical receptacle
of the correct voltage, size, and plug configuration. See the
SPECIFICATIONS section for details.
Form No. HBGCEM-1110
Power ON/OFF Switch
Temperature Control
Figure 9. Standard Control Panel
3. Move the power ON/OFF switch to the ON position.
BURN HAzARD: Some exterior surfaces on unit will get
hot. Use caution when touching these areas.
4. Turn the temperature control to the desired temperature
setting.
5. Allow the unit 30 minutes to reach operating temperature.
The Heated Black Glass shelves have a temperature range
of 38° to 93°C (100° to 200°F).
NOTE: Refer to the OPTIONS AND ACCESSORIES section for
installation and operation information for HBGB units
equipped with the flush-style remote mounted control
panel.
9

OPERATION

CAUTION
HEATED
BLACK GLASS