4.
Adjust leveling feet
Jam nut
Models with
metal feet
or
Models with
plastic feet
If washer is not level:
On models with metal feet, use a 9/16" or 14 mm open-end or
adjustable wrench to turn jam nuts clockwise on feet until they
are about 1/2" (13 mm) from the washer cabinet. Then turn the
leveling foot clockwise to lower the washer or counterclockwise
to raise the washer.
On models with plastic feet, use adjustable pliers to turn the
plastic leveling foot counterclockwise
to lower the washer or
clockwise to raise the washer. On all models, recheck levelness
of washer and repeat as needed.
HELPFUL TIP: You may want to prop up front of washer
about 4" (102 mm) with a wood block or similar object that
will support weight of washer.
_15.
Tighten leveling feet
On models with metal feet, when washer is level, use a
9/16" or 14 mm open-end or adjustable wrench to turn jam
nuts counterclockwise
on leveling feet tightly against washer
cabinet.
HELPFUL TIP: You may want to prop washer with
wooden block.
8
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
COMPLETE
CNEC[(L[ST
INSTALLATmON
Check electrical requirements.
Be sure you have correct
electrical supply and recommended
grounding
method.
Check that all parts are now installed. If there is an extra
part, go back through steps to see what was skipped.
Check that you have all of your tools.
Check that any shipping materials were completely
removed from washer.
Check that water faucets are on.
Check for leaks around faucets and inlet hoses.
Remove protective film from console and any tape
remaining on washer.
Check that washer is plugged into a grounded
3 prong outlet.
Dispose of/recycle all packaging materials.
Read "Washer Care" in your Use and Care Guide.
To test and clean your washer, measure 1/2 of normal
recommended
amount of powdered or liquid detergent
and pour it into washer basket or detergent dispenser
(on some models). Close lid. Select any cycle. Start washer
and allow to complete full cycle.