Assembly Mh-0075-0M10 Model; Assembling Handle; Assembling Cordwrap; Assembly For Mh-0135-0M10, Mh-0190-0M10, Mh-0215-0M10 Models - Mi-T-M MH-0075-0M10 Manual Del Operador

Note: Different models require different assemblies
Note: Tools required for MH-0075-0M10 models: medium phillips screw driver.
Note: Tools required for MH-0135-0M10, MH-0190-0M10, MH-0215-0M10 models: medium phillips screw driver, 5/16" open
end or adjustable wrench, needle nose pliers.
ASSEMBLY FOR MH-0075-0M10 MODEL

ASSEMBLING HANDLE

1. Align the holes in the upper housing with the 2 holes in the handle
as shown.
2. Insert and tighten screws securely with screw driver.

ASSEMBLING CORDWRAP

1. Insert tabs on cordwrap into slots in shell support, lining up the holes on the cordwrap with those on the
side cover.
2. Insert and tighten screws securely with screw driver.

ASSEMBLY FOR MH-0135-0M10, MH-0190-0M10, MH-0215-0M10 MODELS

ASSEMBLING FRAME AND WHEELS

Wheel Support Frame
Tire
Axle Nut
1. Insert axle through holes in wheel support.
2. Slide then spacer onto axle.
3. Slide wheel onto axle with the air valve facing out
and hold in place with the axle nuts.
4. Place heater on the assembled frame, making
sure that the air inlet end is by the wheels, and the
mounting holes on the tank flange of the heater
align with holes in frame.
5. Take the front handle and align the mounting holes
with the corresponding holes in the tank flange/
wheel frame. Slide a screw through the holes and
loosely attach a nut. Repeat for the other 3 holes,
then fully tighten all 4 screws and nuts.
6. Repeat this process with the rear handle.
Kerosene Portable Heaters Manual
ASSEMBLY
Handle
Axle
Spacer
Wheel
Support
Frame
Nut
Thermostat Knob
Hot Air
Outlet
Wheel Tube Valve
Wheel (Pneumatic)
Handle
Screw
Cord Wraps
Air Inlet
Fuel Tank Flange
Axle
11