DeWalt DW030 Manual De Instrucciones página 4

WARNING: Use of controls or adjustments or performance
of procedures other than those specified herein may result in
hazardous radiation exposure.
WARNING! DO NOT DISASSEMBLE THE DEVICE. There are
no user serviceable parts inside. Disassembling this device
will void all warranties on the product. Do not modify the
product in any way. Modifying the tool may result in hazardous
laser radiation exposure.
• The label on your tool may include the following symbols.
V ......volts, direct current
DC
mW .....milliwatts
FIG. 1
• For your convenience and safety, the following labels are on your
laser (Fig. 1).
CAUTION: CLASS 2 LASER RADIATION. DO NOT
STARE INTO THE BEAM.
nm ..... wavelength in nanometers
... laser warning symbol
Laser Information
The DW030 is listed as a CLASS 2 LASER PRODUCT and
complies with the applicable requirement of title 21 of the Code
of Federal Regulations set forth by: the Department of Health,
Education, and Welfare; the Food and Drug Administration; the
Center for Devices and Radiological Health.
These devices comply with Part 15 of the FCC Rules. Operation
is subject to the following two conditions: (1) this device may
not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause
undesired operation.
NOTE: This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to
Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance
with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does
cause harmful interference to radio and television reception, which
can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the
following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Consult the dealer or an experienced radio/TV technician for
help.
These Class B digital devices comply with Canadian ICES-003.
2