Service Interval - Industrial Air IH1393075 Manual Del Operador

CLEANING THE AIR FILTERS
A dirty air filter
will reduce the
compressor's
performance and life.
To avoid any internal
contamination of the
pump, the filters should
be cleaned frequently,
and replaced on a
regular basis. Felt filters
should be cleaned in
warm, soapy water, rinsed, and allowed to air dry before
reinstallation. Paper filters should be replaced when dirty. Do not
allow the filters to become filled with dirt or paint. If the filter
becomes filled with paint, it should be replaced. Direct exposure
to dirty conditions or painting areas will void your warranty.
CHECKING THE RELIEF VALVE
Pull the tank safety valve daily to ensure that it is operating
properly and to clear the valve of any possible obstructions.
TESTING FOR LEAKS
Check that all connections are tight. A small leak in any of
the hoses, transfer tubes, or pipe connections will substantially
reduce the performance of your air compressor. If you suspect
a leak, spray a small amount of soapy water around the area
Perform the following maintenance at the intervals indicated below.
Inspect air filters (clean or replace as necessary)
Check pump oil level
Check engine oil level
Change pump oil (Use synthetic blend, nondetergent air compressor oil.)
Change engine oil (see ENGINE MANUAL (supplied))
Operate the tank safety valve
Check belt tension
Drain tank
Check and tighten all bolts (do not over tighten)
Gasoline engine maintenance (see ENGINE MANUAL (supplied))
200-2967
A = Wing nut
B = Metal cover
C = Filter element
A
B
C

SERVICE INTERVAL

MAINTENANCE
of the suspected leak with a spray bottle. If bubbles appear,
repair or replace the faulty component. Do not over tighten any
connections.
STORAGE
Before storing the compressor for a prolonged period, use an
air blow gun to clean all dust and debris from the compressor. Pull
the tank safety valve to release all pressure from the tank. Drain
all moisture from the tank. Clean the filter elements and filter
housings; replace the elements if necessary. Drain the oil from the
pump crankcase and replace it with new oil. Cover the entire unit
to protect it from moisture and dust.
Daily
or after
each use
9 - ENG
Every 200 Every 250
operating operating
hours hours
•
•
•
•
•
•
•
After first 8 hours
and then every 100
operating hours
•