Location And Function Of Parts And Controls - Sony PVM-5041Q Manual De Instrucciones

Location and Function of Parts and Controls

Front
1 POWER switch and indicator
Depress to turn the monitor on. The indicator will light
up in green.
The POWER indicator also functions as the battery
indicator. When the internal battery becomes weak or
the power supplied through the DC12V IN jack
decreases, the indicator flashes.
2 VOLUME control
Turn this control clockwise or counterclockwise to obtain
the disired volume.
3 CONTR (contrast) control
Turn clockwise to make the contrast stronger and
counterclockwise to make it weaker.
4 PHASE control
Turn clockwise to make the skin tones greenish and
counterclockwise to make them purplish.
5 CHROMA control
Turn clockwise to make the color intensity stronger and
counterclockwise to make it weaker.
Note
• The PHASE and CHROMA control settings have no
effect on an analog RGB signal.
• The PHASE control has no effect on component signals.
• The PHASE control setting is effective only for the NTSC
system.
2
Rear
6 BRIGHT (brightness) control
Turn clockwise for more brightness and
counterclockwise for less.
7 H/V DELAY selector
Depress this button to observe the horizontal and
vertical sync signals at the same time. The horizontal
sync signal is displayed in the left quarter of the screen;
the vertical sync signal is displayed near the center of
the screen.
8 LINE/RGB input selector
Select the program to be monitored. Keep this button
released (LINE) for a signal fed through the LINE
connectors. Depress this button (RGB) for a signal fed
through the RGB/COMPONENT connectors.
9 BLUE ONLY selector
Depress this button to turn off the red and green
signals. A blue signal is displayed as an apparent
monochrome picture on the screen. This facilitates
"chroma" and "phase" control adjustments and the
observation of video noise.
!º UNDER SCAN selector
Depress this button for underscanning. The display size
is reduced by approximately 3% so that four corners of
the raster are visible.
With this buton depressed, if the UNDER SCAN 4:3/
16:9 selector on the rear panel is set to 16:9, the ratio of
the picture cahnges to 16:9.