SOMFY FREEROLL RTS Manual De Instalación página 20

3. Push and hold the CLOSE (down) button, the cover LED will go:
Warning! Release the button WHILE the LED is SOLID GREEN
FLASHING RED - SOLID RED (5 sec) - SOLID AMBER (2 sec) - SOLID GREEN (2 sec).
The Safety Edge Transmitter is deleted. If successful, it should flash RED-AMBER-GREEN.
To confirm the Safety Edge Transmitter has been deleted, if you try and delete again the first LED
stage is FLASHING GREEN.
b. Learn the Safety Edge Transmitter
1. Make sure the Magnets are correctly fixed on the guides.
2. Make sure there is no Safety Edge Transmitter loaded by setting Switch 4 of DIP 1 to
the ON position, then pressing the CLOSE (down) button.
The cover LED should be FLASHING GREEN to indicate no Safety Edge Transmitter loaded.
Warning! If LED is FLASHING RED then you need to delete the Safety Edge Transmitter
following the procedure above.
3. Press the STOP button
The cover LED should flash AMBER.
4. Press the CLOSE (down) button
The cover LED on FREEROLL will be FLASHING GREEN for learning the Safety Edge
Transmitter on to the FREEROLL.
5. Press the DECOMM button on the back of the Safety Edge Transmitter board 5 times
On each press the LED on the front of the Safety Edge Transmitter will flash each time until this
LED stays ON solid for 4 sec and will then flash dimly for 7 sec before turning off.
Warning! The Safety Edge Transmitter must be connected to the safety edge with the 2 pins
connector.
Watch the cover LED on FREEROLL and it will change from FLASHING GREEN to SOLID
GREEN for 2 sec and this is the confirmation that the Safety Edge Transmitter has been
successfully learnt.
The cover LED on FREEROLL will revert to FLASHING AMBER.
6. Then set Switch 4 of DIP 1 to the OFF position.
7. Then fit the cover on the FREEROLL and commission the safety edge again (cf.
FULL INSTALLATION §6 page 33).
40