Program The Safety Edge Transmitter - SOMFY FREEROLL RTS Manual De Instalación

System Status
Cover LED signal and cause
A rapid RED, GREEN then AMBER
single flash
Indicates that a signal has been received
from a transmitter that has not been loaded
onto the system.
Long AMBER then 2 short RED flashes
PEC has failed Self Check test.
Long AMBER then 3 short RED flashes
The roller shutter door limits are set on top
of one another.
Long RED then short RED flash
Reduced operating range
Batteries in transmitter are flat.
Aerials may not be fitted to remote control
unit.
Aerials may be touching.
The door stops automatically after the
bottom edge of the door has passed the
TOP Magnet when the door is closing
(this only applies when bottom slat
safety edge is installed).
1. Signal interference.
2. Aerials are touching or have been
removed.
3. The TOP Magnet is missing or in wrong
location.
4. Fault detected in safety edge circuit.

2. Program the Safety Edge Transmitter

The STOP and CLOSE (Down) buttons used are on the electronic
board.
a. Delete the Safety Edge Transmitter
1. Remove the cover of the FREEROLL unit and follow the
procedure with the control unit idle (no door movement).
2. Put Switch 4 of DIP 1 ON.
The cover LED flashes AMBER.
Solution
Load the transmitter on to the system as per the
"Programming" page 39
1. Check the PEC wiring.
2. Check that PEC has self-check facility.
Swap the brown and the black wires of the motor.
Check link between T11 and T12 on the terminal.
1. Transmitter LED does not illuminate
when flat and if batteries low it flashes when button
pressed. Replace batteries.
2. Ensure aerials are not touching; replace aerials if
they are missing.
3. The door can be closed by pressing and holding a
close button. Release the button once the door is
fully closed.
1. A local device(a wireless HI-FI helmet, a PIR
detector, weather station or TV signal booster...) is
transmitting on the same frequency. The receiver will
wait for the signal to stop before operating the door.
2. Ensure aerials are not touching.
3. Follow instructions for positioning and fitting top
magnet.
4. If the bottom slat transmitter is flashing 6 or 8
times, contact your supplier.
STOP
CLOSE
39