Service/Maintenance Of Air Regulator - SATA air vision 5000 Instrucciones De Servicio

fastening module to the air regulator
with the screws.
Exchange protection cap.
The protection cap [13-2] is mount-
ed on the left adapter plate [13-4]
of the carrying strap by the manu-
facturer.
Changing to the right adapter plate
■ Push the release lever
inward.
■ Pull off the protection cap upwards.
■ Slide in the protection cap on the right
adapter plate.
■ The safety projection
place on the release lever.
11.2. Control operation air
regulator
Attach air regulator to the carry-
ing strap
■ Slide in the air regulator adapter plate
[14-2]
on the left or right adapter
[14-4]
plate of the attached carrying
strap until the safety projection catch-
es on the release lever
■ Angle the air regulator from the base
[15-1]
position
[15-3]
backward
positions at 22.5° and 45° respec-
tively.
Operating Manual SATA Breathing Protection System
[13-1]
[13-3]
locks in
[14-3]
.
[15-2]
forward or
, if required. Locking
Notice!
Only use heat-resistant, anti-stat-
ic, undamaged, technically flaw-
less SATA safety compressed air
tubes with permanent pressure
of at least 10 bar, e.g. article no.
49080 (6 m), 176792 (10 m),
180851 (40 m). These tubes may
not be combined with each other
or extended.
Ensure operational readiness of
air regulator.
■ Connect the compressed air tube with
the compressed air supply connection
[2-5]
.
■ Insert the breathing air tube in the
breathing protection hood connection
[2-6]
.
■ Thread the breathing air tube through
the belt loop.
■ Check the signal whistle of the
breathing protection hood with the air
volume flow controller
■ If required, connect compressed air
tube to the spray gun connection
[2-3]
.
■ The air regulator is operationally
ready.
12. Service/maintenance of
air regulator
The air regulator is mainte-
nance-free. Spare parts are avail-
able for maintenance (see chapter
17).
EN
[2-2]
.
117