Product-Dependent Symbols; Symbols On The Product; Product Information; Declaration Of Conformity - Hilti SF 2-A Manual De Instrucciones

These numbers refer to the corresponding illustrations found at the
beginning of these operating instructions
The numbering reflects the sequence of operations shown in the
illustrations and may deviate from the steps described in the text
Item reference numbers are used in the overview illustrations and
refer to the numbers used in the product overview section
This symbol is intended to draw special attention to certain points
when handling the product.
Wireless data transfer

1.3 Product-dependent symbols

1.3.1 Symbols on the product

The following symbols are used on the product:
Rated speed under no load
Revolutions per minute
Direct current (DC)
Drilling without hammer action

1.4 Product information

Hilti products are designed for professional use and may be operated, ser-
viced and maintained only by trained, authorized personnel. This personnel
must be informed of any particular hazards that may be encountered. The
product and its ancillary equipment can present hazards if used incorrectly
by untrained personnel or if used not in accordance with the intended use.
The type designation and serial number are stated on the rating plate.
▶ Write down the serial number in the table below. You will be required to
state the product details when contacting Hilti Service or your local Hilti
organization to inquire about the product.
Product information
Drill/driver
Generation:
Serial no.:

1.5 Declaration of conformity

We declare, on our sole responsibility, that the product described here
complies with the applicable directives and standards.
declaration of conformity can be found at the end of this documentation.
The technical documentation is filed here:
18 English
Printed: 15.03.2019 | Doc-Nr: PUB / 5174884 / 000 / 02
SF 2-A | SFD 2-A
01
2081398
*2081398*
A copy of the