Preparation For Use - DeWalt D55690 Manual De Instrucciones

CAUTION: Risk of property damage. The wheels and handle do not
provide adequate clearance, stability or support for pulling the unit
up and down stairs or steps. The unit must be lifted, or pushed up
a ramp.
When transporting the
compressor in a vehicle,
trailer, etc. ensure that the air
tank is drained and the unit is
secured and placed on a flat
horizontal surface. note:
Use recommended tie down
points (R) when transporting.
Use care when driving so to
avoid tipping the unit over in
the vehicle. Damage can
occur to the unit or surrounding
items if unit is tipped. Use a
ramp if loading or unloading
the unit from a height of more
than 12" (30.5 cm).
lIftInG
WARNING: Risk injury from lifting. Unit weighs more than 160 lbs.
(72.6 kg) Do not move or lift without assistance.
Always use at least two people when lifting and lift from the
recommended lift points (S).
MoVInG
1. Grasp handle (T) of compressor, and lift compressor high
enough so unit can be rolled on the front tire(s).
WARNING: Risk of unsafe operation. Ensure proper footing and
use caution when rolling compressor so that unit does not tip or
cause loss of balance.
R, S
R, S
R
T
R, S
R, S
T
R
2. When location is reached slowly lower compressor to ground.
Always store compressor in a horizontal position.
note: Should the unit tip over, hard starting and smoking will occur
due to oil spillage.

PrEPArATIon For uSE

Pre-Start Checklist (Fig. 1)
1. Ensure engine START/RUN/OFF switch (C) is in the OFF
position.
2. Ensure air tank is drained, see Draining Air tank under
Maintenance.
3. Ensure the drain valve (J) is closed.
4. Ensure safety valve (I) is functioning properly, see Checking
safety Valve under Maintenance.
5. Check pump oil level, see Compressor Pump oil under
Maintenance.
CAUTION: Do not operate without oil or with inadequate oil. D
is not responsible for compressor failure caused by inadequate oil.
6. Check engine's oil and fuel level, see engine's instruction manual
for correct procedures.
7. Visually inspect drive belt. Replace belt if frayed, cracked, or worn.
note: Outer belt cover must be removed to inspect drive belt.
8. Ensure all guards, covers, and labels are in place, legible (for
labels) and securely mounted. Do not use compressor until all
items have been verified.
Initial Set-up (Fig. 1)
WARNING: Do not operate this unit until you read this instruction
manual and the engine instruction manual for safety, operation and
maintenance instructions.
18
WalT
e