Tilt Mode Configuration - Promax 8 plus Manual Del Usuario Y Operador

INSTRUCTION MANUEL. PROMAX-8+
To access
operation press the TILT key [12]. The
screen will show a bar-graph of the four
pilot channels and the difference in level (TILT)
between the upper pilot and the lower pilot (- 5 dB
in the example). When the pilots are not present or
its level is lower than 20 dBµV, the message 'NO
PILOTS' will appear. Turning the rotary selector [9] the
reference level may be modified.
The pilots may be defined in two ways:
a) By frequency
Using the TILT configuration menu. See section 4.2.5.1 Tilt mode configuration.
b) By channel (only pilots in the forward band).
From the SCAN mode. In order to do this:
1. Place the marker over the channel you want as low pilot.
2. Press the SCAN key [11], and the message 'PILOT 1: PRESS TILT'
will appear at the bottom of the screen.
3. Keeping the SCAN key [11] held down, press the TILT key [12], and a
message 'PILOT 1 ENTERED' will appear as confirmation.
Repeat the steps 1 to 3 for the 3 following pilots.
4.2.5.1

TILT mode configuration.

Pressing the CONFIG [14] key
will access to the first page of the
configuration menu.
To change a given parameter turn the
rotary selector [9] until the field is activated (this will
appear shadowed) and then press. The value of
the parameter will be activated and may be
changed by turning the rotary selector. When the value you want appears, press the
rotary selector [9] to validate it.
a) BAND
It permits to select between the FORWARD mode (5 to 862 MHz) and the
REVERSE mode (5 to 100 MHz).
b) F. PILOT 1
It defines a frequency belonging to the forward band (from 5 to 862 MHz) where
the first measurement of level will be done. This parameter, and the rest of
pilots, is defined digit by digit, by pressing repeatedly and turning the rotary
selector.
May 2001
this mode of
Figure 34.- TILT mode.
Figure 35.- ConFigureción de TILT.
Page 33