Connection To A Computer Or Printer; Configuration; Data Logger - Promax 8 plus Manual Del Usuario Y Operador

INSTRUCTION MANUEL. PROMAX-8+
b) MEASURES: It defines the types of measurements to be made.
- Level
- Lev - V/A - C/N : Level, Video to Audio and Carrier to Noise ratios. V/A ratio
is only performed on analogue channels.
To leave the configuration menu of the DATA LOGGER mode, just press the key
of the operating mode you wish to access.
4.3

Connection to a Computer or Printer.

The PROMAX-8+ permits the connection to a PC or to a serial printer for data
transfer, by means of the connection cable model CC-208.
Do not connect any cable other than that supplied by the manufacturer,
otherwise serious damage may be caused to the equipment.
1) Prior to connecting the equipment to a PC, disconnect both from their
respective power supplies.
2) Connect the end of the connection cable corresponding to the PROMAX-8+
to connection [8] and the other end to the serial port of your computer or
printer.
Once the computer or printer have been connected, select on the PROMAX-8+
the LOGGER operation mode. If PRINT function is selected data will be dumped to the
remote unit through the serial port.
The communication parameters used by the PROMAX-8+, and which therefore
must be defined on the remote unit (PC or printer) are the following:
Rate
Data bits
Parity
Stop bits
The remote control software RM-008+ (optional accessory) permits to carry out
from a computer the following options:
1) CHANNELS PLAN PROCESSOR: Modify, add or delete channel plans.
2) CONFIGURATION: Permits to modify all the configuration parameters.
3) DATA LOGGER: Permits to edit and to save all the measurement contained in a
logger.
4) UPDATE: Allows to update the PROMAX-8+ software version.
May 2001
19200 bauds
8 bits
None
1
IMPORTANT
Page 37