Data Logger Operating Mode - Promax 8 plus Manual Del Usuario Y Operador

c) F. PILOT 2
It defines the second pilot frequency belonging to the forward band.
d) F. PILOT 3
It defines the third pilot frequency belonging to the forward band.
e) F. PILOT 4
It defines the fourth pilot frequency belonging to the forward band.
To accede to the second page of
the TILT configuration menu, press the
CONFIG key again. This screen permits
to define the frequencies of the pilots
belonging to the reverse band (from 5 to 100 MHz).
As in previous screen, the frequencies are defined
digit by digit.
To leave the configuration menu of the TILT mode, just press the key of the
operating mode you wish to access.

4.2.6 DATA LOGGER operating mode.

The LOGGER function permits to automatically measure the level, the
Carrier/Noise ratio and the Video/Audio ratio (the latter only in the case of analogue
channels) of each active channel in the channel plan (see paragraph Channel Plan
editor at section 4.2.1. Unit Global Configuration) . These measurements are stored in
the memory so that they can be subsequently viewed, printed or transferred to a PC.
The PROMAX-8+ will store up to 55 obtained channels or loggers in the memory, with a
maximum of up to 140 analyzed channels in each.
When pressing the LOGGER
[16] key, a screen similar to the one of
the attached figure will appear. The first
line shows the logger number (i.e. 53
in the attached figure) followed by the date it was
acquired (only if MEASURE function was executed
on that logger previously). Below, the different
functions you can perform from this operating
mode are shown: VIEW, MEASURE and PRINT.
On the bottom of the display appears present time and date. To modify them
see section 4.2.1 Global Configuration Menu.
Page 34
INSTRUCTION MANUEL. PROMAX-8+
Figure 36.- TILT configuration. 2/2
Figure 37.- LOGGER functin. Initial
menu.
IMPORTANT
May 2001