Storage - Schumacher IP-1800I Manual Del Usuario

NOTE: Estimated run-times. Actual time may vary. Times are based on
the internal battery being fully charged
5.6 Flex-Light
To use the flex-light, insert the light's plug into the 12V accessory outlet.
The ON/OFF control is on the back of the light.
Light Replacement
The bulb used in the Instant Power™ light is a 12 volt, 5 watt halogen bayo-
net type. Since the bulb needing replacement is not working and the switch
may be in the ON position, the lamp circuit could be "live". Use caution
while changing the bulb.
1. Disconnect the light from the 12V accessory outlet.
2. To replace the bulb, unscrew the cover on the lamp back, remove the
old bulb, then replace with a new 12 volt, 5 watt halogen bulb.
3. Finally, screw the cover onto the lamp housing.
6.

STORAGE

IMPORTANT:
• CHARGE IMMEDIATELY AFTER PURCHASE
• KEEP FULLY CHARGED
Charge the Instant Power™ internal battery before first use and after
every use thereafter.
All batteries are affected by temperature. The ideal storage temperature is
at 70 degrees Fahrenheit. The internal battery will gradually self-discharge
(lose power) over time, especially in warm environments. Leaving the
battery in a discharged state may result in permanent battery damage. To
ensure satisfactory performance and avoid permanent damage, charge
the internal battery every month.
The clips on the Instant Power™ are live and will produce arcing or spark-
ing if they come in contact with each other. To prevent accidental arcing,
always keep the clips on the storage holders when not using it to jump
start a vehicle.
8
• •