Care And Cleaning - Vitamix 750 Serie Manual Del Usuario

To prepare your new blender for initial use, follow the steps under Normal
Cleaning, below. This will clean the unit and break in the motor.
During your first few uses, you may notice a slight burning odor as the motor is
primed. This is completely normal and will dissipate quickly.
Normal Cleaning
Before using the Variable Speed or Program options,
always begin with the Variable Speed Dial pointed at
the Stop Symbol ( ) at the top of the dial.
1. Fill the container half full with warm water and add
a couple drops of liquid dish washing detergent to
the container.
2. Snap or push the complete 2-part lid into the locked position.
3. Perform one of the following procedures:
•
Variable Speed:
a. Rotate the Variable Speed dial to 1.
b. Press the Start / Stop switch.
c. Slowly increase Variable Speed to 10.
d. Run the blender for 30 to 60 seconds.
e. Rotate the Variable Speed dial to the Stop Symbol ( ) at the top of the dial.
•
Program:
a. Rotate the Variable Speed dial to the Cleaning ( ) program icon.
The Cleaning ( ) program will run for approximately 1 minute.
b. After the program stops, rotate the Variable Speed dial to the
Stop Symbol ( ) at the top of the dial.
4. Rinse and drain the container.
To Sanitize
Before using the Variable Speed or Program options, always begin with the
Variable Speed Dial pointed at the Stop Symbol ( ) at the top of the dial.
1. Follow the cleaning instructions above.
2. Fill the container half full with water and 1 ½ teaspoons of liquid bleach.
3. Snap or push the complete 2-part lid into the locked position.

CARE AND CLEANING

41