Lighting Instructions; To Turn Off Gas To Appliance - Pleasant Hearth VFL2-VO24DR Manual De Uso

Ocultar thumbs

Tabla de contenido

Idiomas disponibles

OPERATION

1. STOP! Read the safety information as noted above.

2. Set receiver switch to "ON" position (See Fig. 26).

3. Turn control knob clockwise

4. Wait five (5) minutes to clear out any gas. Then smell for gas, including

near the floor. If you smell gas, STOP! Follow "B" in the safety information

as noted above. If you don't smell gas, go to the next step.

5. Push in slightly and turn control knob counterclockwise

"PILOT" position (See Fig. 26). Depress control knob.

6. With control knob depressed, push down on the ignitor button until the

pilot lights. The pilot's location is behind log #3 near the center of the

burner. (See Fig. 27).

7. Keep control knob depressed for (30) seconds after pilot lights. Release

control knob.

• If the control knob does not pop up when released, stop and immediately

call a qualified service technician or gas supplier.

• If pilot goes out repeat steps 3 through 7. Wait (1) minute before attempting

to light pilot again. If after several tries the pilot still goes out, turn the

gas control knob clockwise

service technician.

8. Turn control knob counterclockwise

9. To use the included thermostatic remote control, set receiver switch to

the "REMOTE" position (See Fig. 28). Press the ON button to turn on the

remote to ignite the main burner. Refer to the remote control instruction

manual on the next page for "MODE" and "SET" functions.

WARNING: The fireplace screen must be in place while the appliance is in operation.

WARNING: Any glass doors shall be completely opened while appliance is in operation.

1. Set thermostat to the lowest setting.

2. Press the OFF button on the remote control.

3. Push in slightly and turn control knob clockwise