Ordering Replacement Parts - EINHELL MBF 550 Manual De Instrucciones

Anleitung MBF 550 25.02.2005
Check the spindle for excess vibration.
Check that all the screw connections are tight.
9.1 Lubrication
If consistently good results are to be achieved and
the machine is to be protected against corrosion, it
must be lubricated and greased at regular intervals.
Spread the lubricating oil or grease evenly using a
brush or non-fluffy cloth.
Lubricating points and lubricants:
All bare parts of the machine: Lubricating oil
Tie rod on column: Lubricating oil
Machine table: Lubricating oil
Fine feed mechanism: Lubricating oil
Saddle slide feed spindle: Lubricating oil
Cross slide feed spindle: Lubricating oil
Routing head inverted V-track: Lubricating grease
Routing head pivot bearing: Lubricating grease
Cross slide inverted V-track: Lubricating grease
Saddle slide inverted V-track: Lubricating grease
Special accessories:
The following accessories can be obtained for the
machine:
Machine vice
Clamping claws set (set of 58
Collet chuck set 4-16 mm (set of 9
Indexable insert routing cutter Ø 30 mm
Hard metal indexable inserts

10. Ordering replacement parts

Replacement parts can be ordered through ISC
GmbH (see the warranty declaration for the
address). The following information should be provi-
ded when placing an order:
Model/type of device
Item number of device
I.D. number of device
Number of the required replacement part
9:47 Uhr Seite 21
GB
21