Items Supplied; Proper Use - EINHELL MBF 550 Manual De Instrucciones

Anleitung MBF 550 25.02.2005
1. Layout
1. Routing head
2. Compound table
3. Machine column
4. Work spindle
5. Gear lever
6. Speed selector switch
7. Wheel selector for fine feed
8. ON/OFF switch
9. Ring gear drill chuck
10. Hand crank for cross slide
11. Hand crank for saddle slide
12. Depth stop
13. Fixing nut for angle adjustment
14. Star handle
15. Spindle guard
16. Hinged chip guard

2. Items supplied

Drilling and routing machine
Drill chuck key
Hook spanner
Locating pin
Tools

3. Proper use

This machine is designed for the drilling, deep rout-
ing and face routing of small workpieces (max.
dimensions: 300 mm x 200 mm x 200 mm) made
from metal, plastic or similar materials. Only drilling
and routing tools with a cylindrical shaft of max. 16
mm may be used with the standard ring gear drill
chuck. The tool diameter for the machining of metal
(ST37) must be no more than 13 mm. Tools with a
tapered shank (MK3) can also be mounted directly in
the work spindle. This drilling and routing machine is
suitable only for household use and must not be
used for industrial applications. The machine is to be
used only for its prescribed purpose. Any other use is
deemed to be a case of misuse.
The user/operator and not the manufacturer will be
held liable for damage and/or injuries of any kind that
result from such misuse. To use the machine proper-
ly you must also observe the safety regulations, the
assembly instructions and the operating instructions
to be found in this manual. All persons who use and
service the machine have to be acquainted with this
manual and must be informed about the machine's
potential hazards. It is also imperative to observe the
accident prevention regulations in force in your area.
9:47 Uhr Seite 15
The same applies for the general rules of health and
safety at work.
The manufacturer will not be liable for any changes
made to the machine nor for any damage resulting
from such changes. Even when the machine is used
as prescribed it is still impossible to eliminate certain
residual risk factors. The following hazards may arise
in connection with the machines' construction and
design:
Contact with the jaw chuck where it is not
covered.
Reaching into rotating parts (risk of injury).
Catapulting of workpieces and parts of workpieces
from the machine.
Risk of injury from the cutting tool even when it is
not being used.
Workpieces whose diameter allows them to fall
through the jaw chuck towards the spindle head
must not under any circumstances project beyond
the limit of the machine (risk of injury).
Harmful coolants and lubricants. Make sure they
are disposed of in an environmentally friendly
manner.
Contact with rotating components where they are
not covered. Risk of injury!
Caution! Risk of injury! Always withdraw jaw chuck
keys immediately and never leave them inserted
in the chuck!
Catapulting of workpieces and parts of workpieces
from the machine.
Risk of injury from the routing tool even when it is
not in use.
Eye injuries can be caused by flying chips and
other splinters. You MUST wear safety goggles!
4. Important information
Please read the directions for use carefully and
observe the safety information before using the
machine for the first time. It is important to con-
sult these instructions in order to acquaint your-
self with the machine, its proper use and safety
precautions. Always keep the instructions so that
the user can access them at any time.
It is absolutely essential that personal protective
equipment is worn whenever working with the
machine.
To prevent eye injuries, always wear safety
goggles.
You must wear a hair net or suitable work cap if
you have long hair.
GB
15