Features; Operation Instructions; Intended Use - Urrea SK904 Manual De Usuario

FEATURES

KNOW YOUR TOOL
Before attempting to use this product, become
familiar with all of its operating features and
safety requirements.
WARNING: Do not allow familiarity with the
pendulum jigsaw to cause carelessness.
Remember that a fraction of a second of care-
lessness is enough to inflict severe injury.
3
4
5
6
1. LOCK-ON BUTTON
2. TRIGGER SWITCH WITH VARIABLE SPEED
3. LASER SWITCH
4. LASER GUIDE
5. PROTECTION GUARD
6. TILTING BASE
7. PENDULUM SELECTOR
8. BLOWER BUTTON
9. DUST MANAGEMENT SYSTEM

OPERATION INSTRUCTIONS

Make sure the power is equal to the voltage
shown on the label data. This tool has a dual-
core cable, the cable termination is not pre-
pared for any specific type of plug.
This tool is a jigsaw with pendulum and in turn
has an electronic speed control.
The speed setting with a selection of the pen-
dulum can give a high cutting performance,
and optimum cutting action, this will make the
life of the saw is longer.
INTENDED USE: With this jigsaw, the cutting of
wood, rubber, ceramic, plastic, and metal can
be undertaken. Cut-out work is also possible
with softer materials. Do not use this jigsaw
12
1
2
9
8
7
to cut any health hazardous materials (for ex-
ample asbestos). Movable saw foot allow the
mitre cuts in the angle of 4S degrees on both
sides. Only adults may use this tool.
Vacuuming
Connect a vacuum cleaner to the vacuum con-
nection adapter of the jigsaw. By doing so, an
optimal vacuuming on the workpiece can be
achieved.
IMPORTANT: Some dust resulting from the
operation process can be dangerous. Use a spe-
cial vacuum device when working with materi-
als harmful to their health.
PROTECTING GUARD
The protection guard must be used only with
90 degrees cutting, for angled cutting, remove
the dust cover. In this case use extreme caution
when handling the jigsaw.
INSERTING/CHANGING THE SAW BLADE
WARNING: Unplug the jigsaw before install-
ing or changing the blade.
IMPORTANT: Make sure that the saw blade
is always firmly attached to the saw blade
holder.
WARNING: After switching the power tool
off, do not decelerate the saw blade by press-
ing the blade sideways against a foreign body.
• To replace the saw
blade use the small
allen key and remove
the cover. Loosen
the screw of the saw
blade holder until the
saw blade can easily
be pulled out from it.
• Push the new saw
blade into the saw blade holder. Position the
saw blade teeth in the sawing direction. Make
sure that the back of the saw blade is in the
middle groove of the guiding roller.
• Tighten the screw of the saw blade holder.
• Always store the jigsaw without the saw
blade.
PROTECTIVE CLOTHING
If possible, wear designated gloves for pro-
tection from splinters and shavings. While
working,wear designated protective goggles