Use And Maintenance; Introduction; Cleaning; C.storage Tips - Sunrise Medical Zippie ZM-310 BC Manual De Instrucciones

Z I PP I E Z M- 3 10
The owner and/or Caregiver for the use of this product, is responsible for
making sure that it has been setup and adjusted by a trained service profes-
sional under the advice of a Healthcare Professional. The chair may
require periodic maintenance or certain in-use adjustments that may be
performed by the owner or caregiver.
A. INTRODUCTION
1. Your chair needs regular maintenance for peak performance
and to avoid injury from chair failure, damage or premature
wear.
2. Inspect and maintain this chair per the Safety Checklist.
3. If you detect a problem, make sure to service or repair the
chair before use.
4. At least once a year, have a complete safety check and service
of your chair performed by a supplier.
B. CLEANING
1. Paint Finish:
• Clean the paint finish with mild soapy water monthly.
• Protect the paint with a coat of non-abrasive auto wax every
three months.
2. Motors:
• Clean around motor area weekly with a slightly damp (not
wet) cloth.
• Wipe off or blow away any fluff, dust, or dirt on or around
the motors.
NOTE– You do not need to grease or oil the chair.
3. Upholstery:
• Hand-wash only as needed. Machine washing may damage
fabric.
• Drip-dry only. Heat from a dryer may damage fabric.
NOTE– Washing the fabric may decrease fire retardant properties.
4. Joystick:
• Use a cloth that has been slightly dampened with diluted
detergent. to clean the joystick and boot.
• LCD Screen can be cleaned with a soft, lint free, dry cloth.
NOTE – NEVER use any type of window cleaner, scouring powder, or any
cleanser with solvents such as alcohol, benzene, ammonia, or
paint thinner. Never use abrasive pads or paper towels.
C. STORAGE TIPS
1. Store your chair in a clean, dry area. If you fail to do so, parts
may rust or corrode.
2. Before using your chair, make sure it is in proper working
order. Inspect and service all items on the "Maintenance
Chart".
3. If you store this chair for more than three months, have it
inspected by a supplier before use.
c. Use petroleum jelly to re-grease the terminals after connect-
ing cable to battery. (Completely cover the terminal nut and
bolt, cable clip and any exposed cable with jelly).
D. TIRE PRESSURE
Residual air pressure in tires can cause severe injury. Make sure
you release all air in tire before attempting to service or have your
tires repaired.
127899 Rev. C
WARNING
WARNING
WARNING
1. Drive Wheels:
a. It is important to keep the correct air pressure in your tires
at all times. You can find the correct pressure in Psi, or
Kilopascals on the sidewall of your tire.
b. Remove the air stem cap.
c. Inflate the tire to the proper pressure level (listed on the
tire sidewall)
E. MOTOR BRUSHES
Check the motor brushes every four (4) months for wear. The
brushes should be clean and shiny. Replace worn or blackened
brushes
F. DISPOSING OF BATTERIES
1. All batteries once they have reached the end of their useful
life are deemed to be hazardous waste.
2. For further information on handling and recycling contact
your local recycling authority.
3. Always dispose of product through a recognized agent.
G. ORDERING PARTS
When you order parts, provide the following:
1. Model of chair
2. Serial number of chair
3. Left hand or right hand control
4. Part number, description and quantity of parts you need.
5. State reason for replacement.
H. SAFETY CHECKLIST
You should check the items on this chart at the indicated intervals.
If any of the items are loose, worn, bent or distorted, immediately
have them checked and/or repaired by your Authorized Dealer.
Frequent maintenance and servicing will improve performance,
extend wheelchair life, and help prevent injuries.
NOTE - The user or caregiver should perform these weekly and monthly
checks to maintain safety of the chair. If an item is not working
properly, please contact your authorized dealer.
SAFETY
AND FUNCTION CHECK
Charge Batteries
Check tires for proper inflation level
Check plugs and connectors for
proper connections
Check all moving parts for wear
Visually check all nuts, bolts and
fasteners for looseness or wear
Inspect upholstery for wear
Service by authorized supplier
16
VIII. USE AND MAINTENANCE
WARNING