Switching The Terminal Device On And Off; Opening The Terminal Device In An Emergency - Ottobock 8E33 Serie Instrucciones De Uso

7 Use

7.1 Switching the terminal device on and off

1
2
7.2 Torch
(for terminal devices with built-in torch)
Inserting the batteries (2x CR2032)
To insert the batteries, complete the following steps:

7.3 Opening the terminal device in an emergency

Switching on
1
Move the rocker switch to position 1 until it engages.
The electronics of the terminal device are switched on and the flex­
ion brake is released.
2
Switching off
Move the rocker switch to position 2 until it engages.
The electronics of the terminal device are switched off and the flex­
ion joint is blocked.
1. 2x powerful LEDs
1 to light the working environment
2. On/Off switch
2 Pressing this button turns the torch on or off. If this button is
pressed immediately after switching on, the brightness can be
changed in 3 levels by pressing it again.
3
After about 15 minutes, the torch is switched off automatically.
3. Battery compartment
1) Turn the cover on the battery compartment counter-clockwise and
remove it.
2) Insert 2 CR2032 button cells with the + pole facing the cover.
3) Install the cover. In doing so, make sure the rubber seal is not
damaged.
4) Close the cover by turning it clockwise.
This safety function allows the prehensile arms to be opened regard­
less of the control signals.
► Swing the unlock lever away from the dial (arrow) and open the
prehensile arms manually.
27