Steren MUL-288 Manual De Instrucciones página 61

1. Turn off the power to the circuit under test. Discharge all high-voltage
capacitors.
2. Connect the red lead to the hFEmA
200 mA and "10 A" for up to 10 A; and black to COM terminal.
3. Turn the knob to the "
4. Break the circuit path to be measured. Connect the black wire to the
more negative side of which broke the circuit and the red to the positive
side. (Reverse cables will give you a negative reading.)
5. Turn on the power to the circuit under test and see the measurement.
If a "1" is in display, this indicates an over range, select a higher range.
TEMP terminal for a maximum of
- - -
A" function.
A
COM
600V
Hz
CAT III
MAX 10A
hFE
FUSED
mA
10A
TEMP
MAX 30 sec.
every 15 min.
+
23 23