Maintenance Schedule; Refueling; Engine Oil - Honda GCV140 Manual Del Propietário

Tabla de contenido
Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 23

MAINTENANCE SCHEDULE

Perform at every indicated month/year or operating hour interval,
(1)
whichever comes first.
Regular
Service Period
Before each
Check: Engine oil level
use
Check: Air filter
First month
Change: Engine oil
or 5 hours
Every 3 months
Clean: Air filter
or 25 hours
Every 6 months
Change: Engine oil
or 50 hours
Clean: Air filter
Check: Flywheel brake pad
(if equipped)
Every year
6 month items above plus:
or 100 hours
Check-adjust: Spark plug
Clean: Spark arrester (if equipped)
Check: Blade brake clutch
(if equipped)
Check-adjust: Idle speed
Clean: Fuel tank and filter
Check-adjust: Valve clearance
Every 2 years
Yearly items above plus:
or 200 hours
Replace: Air filter
Replace: Spark plug
Every 2 years
Check: Fuel lines (replace if
necessary)
(1) For commercial use, log hours of operation to determine proper
maintenance intervals.
(2) Service more frequently when used in dusty areas.
(3) Change engine oil every 25 hours when used under heavy load or in high
ambient temperatures.
(4) These items should be serviced by an authorized Honda servicing dealer,
unless you have the proper tools and are mechanically proficient. Refer
to the Honda shop manual for service procedures.
(5) See your equipment manual or Honda engine shop manual.
(6) In Europe and other countries where machinery directive 2006/42/EC is
enforced, this cleaning should be done by your servicing dealer.
Failure to follow this maintenance schedule could result in
non-warrantable failures.

REFUELING

This engine is certified to operate on unleaded petrol with a research
octane rating of 91 or higher.
We recommend refueling after each use to minimize the air present in
the fuel tank.
Refuel in a well-ventilated area with the engine stopped. If the engine
has been running, allow it to cool first. Never refuel the engine inside
a building where petrol fumes may reach flames or sparks.
You may use regular unleaded petrol containing no more than 10%
ethanol (E10) or 5% methanol by volume. In addition, methanol must
contain cosolvents and corrosion inhibitors. Use of fuels with content
of ethanol or methanol greater than shown above may cause starting
and/or performance problems. It may also damage metal, rubber, and
plastic parts of the fuel system. In addition, ethanol is hygroscopic,
which means it attracts and retains water in the fuel system.
8
Item
Page
page 9
page 9
page 9
(2)
page 9
(3)
page 9
(2)
page 9
page 9
page 9
(6)
page 10
(5)
(4)
(4)
(4)
page 9
page 9
(4)
Engine damage or performance problems that result from using a fuel
with percentages of ethanol or methanol greater than shown above
are not overed by warranty.
If your equipment will be used on an infrequent or intermittent basis
(more than 4 weeks between usage), refer to the Fuel section of the
STORAGE chapter (page 10) for additional information regarding fuel
deterioration.
Never use stale or contaminated petrol or oil/petrol mixture. Avoid
getting dirt or water in the fuel tank.
Petrol is highly flammable and explosive, and you can be burned
or seriously injured when refueling.
• Stop engine and keep heat, sparks, and flame away.
• Refuel only outdoors.
• Wipe up spills immediately.
Adding Fuel
See F1 on page 4.
1. Remove the fuel tank cap.
2. Add fuel to the bottom of the red fuel level gauge [1] in the neck of
the fuel tank. Do not overfill. Wipe up spilled fuel before starting the
engine.
3. Install the fuel tank cap and tighten it securely.
Move at least 10 feet (3 meters) away from the fueling source and
site before starting the engine.
NOTICE
Fuel can damage paint and some types of plastic. Be careful not to
spill fuel when filling your fuel tank. Damage caused by spilled fuel is
not covered under your Distributor's Limited Warranty.
Fuel Storage Container
Store your petrol in a clean, plastic, sealed container designed for fuel
storage. Close the vent (if equipped) when not in use, and store the
container away from direct sunlight. If it takes more than 3 months to
use the fuel in the container, we suggest adding a fuel stabilizer to the
fuel when you fill the container. If you have some fuel left in the
storage container at the end of the season, the U.S. Environmental
Protection Agency (EPA) suggests adding the petrol to your vehicle's
gas tank.

ENGINE OIL

Oil is a major factor affecting performance and service life. Use
4-stroke automotive detergent oil. Always change the oil in
accordance with the maintenance schedule.
Recommended Oil
See F2 on page 4.
Use 4-stroke motor oil that meets or exceeds the requirements for API
service category SJ or later. Always check the API service label on
the oil container to be sure it includes the letters SJ or later.
SAE 10W-30 is recommended for general use. Other viscosities
shown in the chart may be used when the average temperature in
your area is within the indicated range.
ENGLISH
 WARNING
Tabla de contenido
loading

Este manual también es adecuado para:

Gcv160Gcv190

Tabla de contenido