Tabla de contenido
9. INSTALLATION (Fig. 4)
Position the plastering machine in a place where it is possible to
have a completely free area of at least 1 metre around it and a
flat treadable surface where only the machine operator stands.
When using the mixing machine the operator must constantly
visually make sure no one else near the work area, and therefore
machine positioning should easily allow the meeting of that
requirement.
The machine must also be placed in such a way as to use the
least possible piping, without any obstacles during use and
cleaning.
Place the machine, correctly positioning the support feet. The
ground on which the machine stands must be firm, and in
particular the feet support points (Ref. 1) must be very solid.
Block the wheels.
- Important! The machine must rest on a flat and
firm surface, so as not to jeopardise the stability of the
plastering machine during use.
Remove the safety pin from the mixing machine (Ref. 4).
Make sure the mixer and hopper grill locking device (Ref. 2) is
activated.
Fold and lock the side impact bar before lowering the mixing
machine (Ref. 3): for safety reasons the motor will not start if
that operation is not carried out.
2
1
Fit the pressure gauge.
Extend the material delivery and air pipes from the machine to
where the product is to be sprayed, avoiding tight bends or
constrictions.
Properly tighten the cam-lock couplings (Fig. 5a/A), making sure
to fit the gaskets and connect the sprayer to the pipe ends.
- Only use original IMER pipes and fittings. The use
of pipes and fittings not complying with IMER
specifications can compromise correct machine
operation as well as the safety of operators.
- Before starting work, always check that the pipes,
fittings and gaskets are in perfect condition.
If present, after correctly positioning it on the hopper, connect
the vibrating screen plug to the special socket on the machine.
If present (always present in the version for self-levelling
material) connect the remote control to the special socket
(Fig. 6, Ref. 1).
IMER INTERNATIONAL S.p.A.
PLASTERING MACHINE SILENT 300, SILENT 300A
4
3
Fig. 4
A
B
2
10. ENGINE AND COMPRESSOR CHECK
Check the engine oil level and the Diesel fuel tank level before
starting work.
11. START-UP (see Fig. 8/9/10)
After placing the machine, prepare three or four buckets of
grout (50% water, 50% cement or lime). Pour the grout into
the machine hopper or, if using colouring products, directly in
the machine piping before connecting it. In which case pour
about 30-40l of coloured product in the hopper.
Take the material pipes, make sure they are in good
condition, the connections are integral and that the relevant
gaskets are present, and connect them to the delivery
manifold and the sprayer. Make sure the cam levers (A) of
the connections are properly secured and that the gasket (B)
is present as shown in Fig. 5a. Close the sprayer air cock
(Fig. 7, Ref. 1). Open the air to machine cock (Fig. 6,
Ref. 2).
Make sure the levers of the distributor (Fig. 8, Ref. 1) are all in
the middle position.
30
Fig. 5a
FIG. 6a
FIG. 6b
Fig. 5b
1
Fig. 6
Tabla de contenido
