Nozzle Attachment - Clatronic BS 1260 Instrucciones De Servicio

Instructions for Use
Intended Use
• The device is intended for use as a wet/dry vacuum cleaner
in accordance with its description and safety instructions.
• The device also has an additional connection with blower
function.
• Any other type of use is considered to be in contradiction of
the intended use and is not permitted.
Attaching the Castors
Before you can use the device you fi rst have to attach the
castors.
Inserting Dust Bags (only for Dry Vacuuming)
The device has a permanent dust bag. This is easy to empty
and can be cleaned.
Motor Protection Filter (15)
The motor protection fi lter is located on the bottom of the motor
housing.
• This is required for both wet and dry vacuuming.
• You should check the condition of the fi lter and that it is
fi rmly in place at regular intervals.
Connecting the Hose
NOTE:
Do not attach the hose until you have inserted the dust bag
fi rst.
05-BS 1260 39
• Place the collection vessel
(5) on its head.
• Attach the castors by tighte-
ning the screws by hand and
then with the spanner.
• Lock the permanent dust bag
with the clip.
• Push the dust bag into the
holder (a).
• Attach the end of the hose
(connection) to the collection
vessel. The locking lugs on
the connecting piece grip
inside the vessel.
• Turn the connecting
piece slightly in a clockwise
direction. The catch lever (b)
points upwards.
• Releasing the hose: Push the catch lever and turn it in an
anticlockwise direction in order to release the hose from the
collection vessel.
Attaching the Motor Housing
NOTE:
• Between the motor housing and the collection vessel there
is a black rubber seal.
• Please ensure that this seal is always inserted and
correctly fi tted in place. If this is not the case the suction
power is lost.
NOTE:
The motor housing can only be attached in one position. The
arrow above the hose connection must point to the arrow
below the on/off switch.
•
•

Nozzle Attachment

Crevice nozzle: For vacuuming upholstery, curtains and
in corners and crevices etc.
Floor nozzle To clean carpets or smooth surfaces.
(only for dry
cleaning):
Smooth Press the lever down with your foot. The
fl oors: brush is now visible.
Carpets: Press the lever In the opposite direction.
The brushes are now retracted.
Parquet brush: The fl oor nozzle is fi tted with rollers for
(also for wet improved manoeuvrability. For large
cleaning) areas such as parquet, laminate or tiles
etc. This brush is also ideally suited to
soaking up water from large surfaces.
Releasing the Pull these off while turning slightly.
nozzles:
Accessories
• The accessories such as the suction tube, hose and nozzles
can be easily joined together.
• Releasing: Pull them off again by turning slightly.
Air Slide
Open the air slide on the hose handle in order to regulate the
airfl ow or to clear any particles sticking to the nozzle.
Line the motor housing up in
such a way that its holder is
located above the clips (6) of
the collection vessel.
Then close the clips.
39
19.09.2006, 12:54:56 Uhr