Installation; Rollers; Shampoo Tank Bracket; Wheels - Clatronic BSS 1309 Manual De Instrucciones

Installation

Before you are able to use the appliance you have to assem-
ble it first. Proceed as follows:

Rollers

1. Plug the black feet left and right on the bottom next to
the outlet opening of the appliance. Secure each with a
screw.
2. Plug the rollers into the bottom of the foot.

Shampoo Tank Bracket

Insert the shampoo tank bracket opposite of the rollers al-
ready mounted. Secure it on both sides each with a screw.

Wheels

Attach the big wheels left and right at the shampoo tank
bracket.
NOTE:
Once the wheels are mounted, it is no longer possible to
detach them!

Carrying Handle

Install the handle with 2 screws onto the engine housing.

Connecting and Detaching the Hose

Suction Function
• Put the hose connection into the suction opening on the
collection vessel. Use the guides to do so.
• Turn the hose connection towards
remove the suction hose twist off the hose connection
counterclockwise.
Blower Function
• Insert the hose connection into the blower opening at the
engine housing. Use the guides to do so.
• Turn the hose connection towards
the suction hose twist off the hose connection clockwise.

2-part Suction Pipe

• Insert one of the suction pipes with the thicker end into
the hose end.
• Insert the other suction pipe with the thicker end onto the
first suction pipe.
• To release the suction pipes, pull them off while turning
them slightly.

Notes on Use

Protective Filter Made of Foam

Beneath the motor, there is a protective filter made of foam.
This is required for both wet and dry vacuuming.
• If not yet in place, put the protective filter over the suction
basket.
44
BSS1309
NOTE:
• The protective filter must fully enclose the suction
basket.
• You should check the condition of the filter and that it is
firmly in place at regular intervals.

Permanent Filter (Only when Vacuuming Dry)

Put the permanent filter over the protective filter.
NOTE:
The permanent filter must fully enclose the suction basket.

Attaching the Motor Housing

• Adjust the motor housing so that the on / off switch (I / O / II)
sits above the suction opening.
• Close both locking mechanisms.

Nozzle Attachment

Wet / Dry Brush
You may vacuum leaked or spilled liquids of flat surfaces,
carpets and parquet with the wet / dry brush.
NOTE:
Check the maximum fill capacity of the collection vessel.
10 litres of liquid without foaming additive!
Shampoo Brush
You may clean carpets with a commercial carpet shampoo by
. In order to
using the shampoo brush.
Upholstery Brush
You may clean upholstery with a commercial upholstery
shampoo by using the upholstery brush.
Crevice Nozzle
. In order to remove
For vacuuming upholstery, curtains and in corners and
crevices etc.

Mains Lead

• Completely unwind the cable during operation.
• After use, allow the motor housing to cool down. You may
wind the cord around the engine housing afterwards.

Turning On / Off

The On / Off switch has several functions:
0 Off
I Wet and dry vacuuming / Blower function
II Vacuuming with shampoo
Switch position II additionally activates the pump.
NOTE:
16.10.17