Continuous Playback; Blank Scan - Teac W-865R Manual Del Usuario

Continuous Playback

2 1 4
3
Continuous playback can be performed between TAPE I and
TAPE II. When one tape is played back to the end, the other tape
automatically starts playback, in a relay fashion.
1
Load pre-recorded tapes into the TAPE I and TAPE II
compartments.
2
Set the Dolby NR switch.
Always set the Dolby NR switch to the same position that was
used for recording.
3
Set the REV MODE switch to the p (CONT PLAY)
position.
4
Press the play button (h or y) of the deck you want to
start first.
You can start continuous playback from either TAPE I or
TAPE II.
Playback cycles through four tape sides as follows:
TAPE I Side "A" w Side "B"
2
TAPE II Side "B" s Side "A"
Playback will automatically stop when both sides of both
tapes have been played back 5 times continuously.
4 1
x

Blank Scan

The Blank Scan function detects 10 seconds or more of blank
and skips over it.
To activate this function, press the BLANK SCAN button followed
by the desired play button (h or y).
< The BLANK SCAN indicator lights when this function is
activated.
< To disable this function, press the BLANK SCAN button again.
The indicator turns off.
< Very quiet passages in music are likely to be identified as
blanks. If you are worried about this, switch off Blank Scan.
13