EVANS.COM.MX PROPIEDAD EVANS.COM.MX PROPIEDAD EVANS.
2.
Check the mower deck for a shipping brace that may be
PROPIEDAD EVANS.COM.MX PROPIEDAD EVANS.COM.MX PROPIE
holding the chute deflector upward for shipment. If the
brace is present, it must be removed before operating the
tractor. Holding the chute deflector fully upward, remove
the shipping brace. Lower the chute deflector and discard
EVANS.COM.MX PROPIEDAD EVANS.COM.MX PROPIEDAD EVANS.
the shipping brace. See Figure 3-3.
PROPIEDAD EVANS.COM.MX PROPIEDAD EVANS.COM.MX PROPIE
EVANS.COM.MX PROPIEDAD EVANS.COM.MX PROPIEDAD EVANS.
PROPIEDAD EVANS.COM.MX PROPIEDAD EVANS.COM.MX PROPIE
EVANS.COM.MX PROPIEDAD EVANS.COM.MX PROPIEDAD EVANS.
PROPIEDAD EVANS.COM.MX PROPIEDAD EVANS.COM.MX PROPIE
EVANS.COM.MX PROPIEDAD EVANS.COM.MX PROPIEDAD EVANS.
WARNING!
PROPIEDAD EVANS.COM.MX PROPIEDAD EVANS.COM.MX PROPIE
packaging purposes only, must be removed and
discarded before operating your riding mower.
EVANS.COM.MX PROPIEDAD EVANS.COM.MX PROPIEDAD EVANS.
WARNING!
throwing objects. Failure to operate the riding
mower without the discharge cover in the proper
PROPIEDAD EVANS.COM.MX PROPIEDAD EVANS.COM.MX PROPIE
operating position could result in serious personal
injury and/or property damage.
Attaching The Steering Wheel
EVANS.COM.MX PROPIEDAD EVANS.COM.MX PROPIEDAD EVANS.
If the steering wheel for your tractor did not come attached, the
hardware for attaching it has been packed within the steering
PROPIEDAD EVANS.COM.MX PROPIEDAD EVANS.COM.MX PROPIE
wheel, beneath the steering wheel cap. Carefully pry off the
steering wheel cap and remove the hardware.
1.
With the wheels of the tractor pointing straight forward,
place the steering wheel over the steering shaft.
EVANS.COM.MX PROPIEDAD EVANS.COM.MX PROPIEDAD EVANS.
PROPIEDAD EVANS.COM.MX PROPIEDAD EVANS.COM.MX PROPIE
EVANS.COM.MX PROPIEDAD EVANS.COM.MX PROPIEDAD EVANS.
PROPIEDAD EVANS.COM.MX PROPIEDAD EVANS.COM.MX PROPIE
EVANS.COM.MX PROPIEDAD EVANS.COM.MX PROPIEDAD EVANS.
PROPIEDAD EVANS.COM.MX PROPIEDAD EVANS.COM.MX PROPIE
10
S
3— A
ection
Figure 3-3
The shipping brace, used for
The mowing deck is capable of
& S
-U
SSembly
et
p
2.
Place the washer (with the cupped side down) over the
steering wheel and secure with the hex bolt. See Figure 3-4.
Figure 3-4
3.
Place the steering wheel cap over the center of the steering
wheel and push downward until it "clicks" into place.
Attaching The Dash Collar (If equipped)
If the tractor's dash collar did not come attached from the
factory, the screws for attaching it can be found in either side of
the dash console. Remove the two screws from the console and
secure the dash collar as illustrated in Figure 3-5.
Figure 3-5
Attaching The Seat
If the seat for your tractor was not attached at the factory, follow
the applicable instructions below to attach it.
NOTE: For shipping reasons, some seats are not attached at the
factory. In this is the case, free the seat from its shipping position: