Intended Use - Weller WMRT Manual De Uso

WMRP/WMRT
PK Elektronik Vertriebs GmbH, E-Mail: [email protected], Internet: www.pkelektronik.com
Handling − Do not place or leave the hot soldering/desoldering tips on the
soldering/ cleaning sponge (2) or on plastic surfaces.
desoldering
− Coat the tin-plated soldering/desoldering tips with solder when
tips
heating the iron for the first time, as this will remove any oxide
films or impurities from the soldering/desoldering tips that have
accumulated during storage.
− During breaks between soldering/desoldering and before storing
the tool, ensure that the soldering/desoldering tips are well-
coated.
− Do not use aggressive fluxing agents.
− Always make sure that the soldering/desoldering tips are seated
correctly.
− Select the lowest possible working temperature.
− Select the largest possible soldering/desoldering tips shape for
the application: approx. as large as the soldering pad.
− Coat the soldering/desoldering tips well to ensure efficient heat
transfer between the soldering/desoldering tips and the soldering
point.
− Switch off the system if you do not intend to use the
soldering/desoldering tool for longer periods.
− Coat the tips before placing the soldering/desoldering tool in the
holder.
− Apply the solder directly at the soldering point, not on the
soldering/desoldering tips.
− Do not subject the soldering/desoldering tips to physical forces.
− Always keep the cleaning sponge (2) damp. Use only distilled or
de-ionized water.
−
Always ensure that the hand piece (5) is properly seated in the
tool holder (1).
2.2

Intended use

Use the WMRP soldering pencil or WMRT micro desoldering
tweezers exclusively for the purpose indicated in the operating
instructions of releasing, accommodating and setting down chip
components under the conditions specified here. Intended use of the
WMRP soldering pencil or WMRT micro desoldering tweezers also
includes that
− you read and follow these instructions,
− you read and follow all additional accompanying documents,
− you observe the national accident-prevention regulations
applicable at the location where the device is used.
The manufacturer accepts no liability for damages resulting from
failure to use the device in compliance with these operating
instructions or unauthorized modifications to the device.
5-12